AgdaPkt 2014-09-08 Closed and Joint with SA

Browse Search

7.1.D. - Page 25 • The hoses are rolled up on three large hydraulic reels designed to save time during the roll-out and roll-up process. • Two sets of hose ramps are supplied for traffic use. • The hose reels are attached to and powered by a small forklift that piggy backs onto the back of the trailer. The forklift is a Burro model from the Quality Corporation out of Denver Co, which can lift 3,000 lbs. The Burro model weighs approx 1,400 lbs. The Burro is powered by a 13 HP Honda gasoline engine and utilizes hydraulics which also powers the reels. The top speed for the Burro is 3 mph and is a walk-behind model. The Burro is equipped with an orange emergency strobe plus forward and back facing lighting for night operations. • A power inverter is installed on the truck to power the turbidity meters, the flow meter and the disinfection systems. • There are two(2")pressure relief valves on the NO-DES Truck Unit. • There are two air relief valves on each filter vessel. • There is a 6" one-way check valve installed. • Four(4) 6"aluminum ells are included(45 and 90 degrees). • Two 4-1/2"hydrant thread by 5" Storz adapters are included. • Two hydrant wrenches and two storz wrenches are included. • Two sets of 2-1/2"to 5" Storz hydrant adapters systems are included. • There are three test taps located in front of the control center—one each prior to each filter inlet, and one each after each filter outlet. • The truck will come with a"headache rack"for mounting emergency lighting. • The truck bed will have a ladder and railings for safety. Control Panel Specs: • There is a flow meter with a remote read display for attaining exact flow information, and a Totalizer for tracking use. • There are truck engine pump(PTO) controls. • Two HACH turbidity meters are standard(inside the control panel). One turbidity meter for testing inlet water that is prior to the pump (at the inlet) and one turbidity meter for testing outlet water that is testing water at the outlet of the polishing filter. • Disinfection equipment included that provides for the addition of disinfectants as determined by the Buyer • Pressure gauges are located on the control panel to aid in system operation monitoring and control. Filter Bag Replacement Restrictions Buyer must replace the standard #2, 1 micron absolute filter bags with authorized Fil-Trek Replacement Bags. Fil-Trek 1 micron absolute pleated bags model#MPG-PO-1-2-BN. Failure to use the above referenced authorized Fil-Trek replacement bags will void Seller's limited warranty in its entirety. Seller will provide Buyer with the contact information for purchase of Fil-Trek filter bags through NO- DES, Inc. Buyer's Initials REV:07-22-14 MLG Page 11 of 11