Laserfiche WebLink
9.A. - Page 17 <br /> Funeral Homes and - <br /> Mortuaries <br /> Nursing or Rest Homes - <br /> 5.3 Lot Area. <br /> A. Minimum Area. The minimum lot area requirement is 10,000 square feet for the <br /> RH Zoning District and 6,000 square feet for the R-1 Zoning District, with <br /> exceptions to these requirements described in subsections B and C. <br /> B. Greater Minimums with a Numerical Suffix. Greater minimum lot areas may be <br /> established by adding a numerical suffix to the district designation in conjunction <br /> with the zoning of any property. The number is part of the District designation and <br /> establishes the minimum lot area in thousands of square feet (for example, RH-20 <br /> establishes a minimum lot area of 20,000 square feet). <br /> C. Supplementary Lot Area Requirements for Sloping Sites. Additional <br /> requirements for lot subdivisions in sloping areas are located in Section 32.2 <br /> (Supplementary Lot Area Requirements for Sloping Sites). <br /> 5.4 Lot Width. <br /> The minimum lot width is 60 feet in the RH Zoning District and 50 feet in the R-1 Zoning District. <br /> Each lot shall have a minimum of 35 feet of frontage on a publicly accessible street. <br /> 5.5 Lot Coverage. <br /> Total lot coverage is limited to 40 percent of the lot area. Not more than 40 percent of the required rear <br /> yard shall be covered by accessory buildings. <br /> 5.6 Building Height. <br /> Maximum building height is 28 feet and structures shall not exceed 2.5 stories. See Section 32.10 <br /> (Accessory Buildings) for accessory building height regulations. See Article 2 (Definitions) for <br /> information on how"story" and"height of building" are measured. <br /> Figure 5.6 Building Height (for illustrative purposes only) <br /> Half story <br /> Full story Max. 28 ft. <br /> Full story or 2 1/2 stories <br /> Full story Full story <br /> ATTY/ORD.408/ZONING ORD AMENDMENT—HILLSIDE <br /> REV:04-03-15 VR <br /> Page 5 of 18 <br />