Laserfiche WebLink
<br />ATTY/ORD.408/ZONING ORD AMENDMENT 2ND READING– HILLSIDE <br />REV: 06-12-15 VR-RS <br />Page 6 of 19 <br />Funeral Homes and <br />Mortuaries <br /> - <br />Nursing or Rest Homes - <br /> <br />5.3 Lot Area. <br />A. Minimum Area. The minimum lot area requirement is 10,000 square feet for the <br />RH Zoning District and 6,000 square feet for the R-1 Zoning District, with <br />exceptions to these requirements described in subsections B and C. <br />B. Greater Minimums with a Numerical Suffix. Greater minimum lot areas may be <br />established by adding a numerical suffix to the district designation in conjunction <br />with the zoning of any property. The number is part of the District designation and <br />establishes the minimum lot area in thousands of square feet (for example, RH-20 <br />establishes a minimum lot area of 20,000 square feet). <br />C. Supplementary Lot Area Requirements for Sloping Sites. Additional <br />requirements for lot subdivisions in sloping areas are located in Section 32.2 <br />(Supplementary Lot Area Requirements for Sloping Sites). <br /> <br />5.4 Lot Width. <br />The minimum average lot width is 60 feet in the RH Zoning District and 50 feet in the R-1 Zoning <br />District. Each lot shall have a minimum of 35 feet of a public street or private street (privately <br />owned and maintained but publicly accessible.)” <br /> <br />5.5 Lot Coverage. <br />Total lot coverage is limited to 40 percent of the lot area. Not more than 40 percent of the required <br />rear yard shall be covered by accessory buildings. <br /> <br />5.6 Building Height. <br />Maximum building height is 28 feet and structures shall not exceed 2.5 stories. See Section 32.10 <br />(Accessory Buildings) for accessory building height regulations. See Article 2 (Definitions) for <br />information on how “story” and “height of building” are measured. <br /> <br />Figure 5.6 Building Height (for illustrative purposes only) <br />7.4.A. - Page 8