Laserfiche WebLink
6.4.A. - Page 7 <br /> EXHIBIT B <br /> Revisions to Article 5: RH (Residential — Hillside) and R-1 <br /> (Residential-Single Family) Districts <br /> Article 5 - RH (Residential - Hillside) and R-1 (Residential-Single Family) Districts <br /> Sections: <br /> 5.1 Purpose. <br /> 5.2 Uses Allowed by District. <br /> 5.3 Lot Area. <br /> 5.4 Lot Width. <br /> 5.5 Lot Coverage. <br /> 5.6 Building Height. <br /> 5.7 Setback Requirements. <br /> 5.8 Additional Regulations for Sloping Lots. <br /> 5.9 Pervious Area and Stormwater Requirements. <br /> [All sections not listed below remain unchanged.] <br /> 5.5 Lot Coverage. <br /> Total lot coverage is limited to 40 percent of the lot area. Not more than 40 50 percent of the <br /> required rear yard shall be covered by any combination of accessory buildings or an accessory <br /> dwelling unit subject to Section 36.5 (Accessory Buildings) and Article 37 (Accessory Dwellings). <br /> 5.6 Building Height. <br /> Maximum building height is 28 feet and structures shall not exceed 2.5 stories. See Section 32.10 <br /> 36.5 (Accessory Buildings) and Article 37 (Accessory Dwelling Units) for accessory building and <br /> accessory dwelling unit height regulations. respectively. See Article 2 (Definitions)for information <br /> on how "story" and "height of building" are measured. <br /> 5.7 Setback Requirements. <br /> B. Applicability. Setbacks in this section apply to main buildings. See Article 36 for further <br /> information on setbacks for fences, accessory structures buildings, or other types of <br /> improvements. See Article 37 for setback information regarding accessory dwelling units. <br /> ATTY/ORD.417/ADOPTING ADU ORD&RELATED CODE CHANGES <br /> REV: 11-23-15 VR <br /> Page 4 of 13 <br />