Agmt16 Cascade Drilling, L.P. - Laserfiche WebLink

Browse Search

EXHIBIT "A" SCOPE OF SERVICES Task 1 — Health and Safety Plan • Contractor will prepare a site-specific project Health and Safety Plan (HASP) and job safety analyses for the City's review and approval prior to start of pilot test activities. The HASP will include site security, traffic control measures and temporary no parking zones. • Contractor will conduct one Health and Safety Loss Prevention Observation (LPO) per every five days of site activities during the project. Copies of the completed LPOs are to be provided to the City within one week of the observation. • Contractor will use, at a minimum, Level D Personal Protective Equipment (PPE) during the project. Level C PPE should be available at all times should an upgrade be required. • Contractor shall conduct daily safety meetings prior to initiating any site activities. Task 2 _ Preconstruction Kickoff Meeting • Contractor shall attend the pre-construction kickoff meeting. Task 3 — Site Security and Traffic Control Measures • Contractor will maintain public safety and minimize impacts to property: O 1 . Confine all operations to areas permitted by the City O 2. Do not encumber site with excessive material or equipment O 3 . Do not impose any load on any structure that will damage or endanger structure O 4. Take precautions necessary to prevent annoyance to occupants adjacent to or in the vicinity of the work O 5. Contractor is solely responsible for conditions of the jobsite, including safety of all persons and property during performance of work. This applies continuously and is not limited to normal working hours. Contractor shall maintain safety and sanitary provisions so that they conform to applicable Federal, State, County and local laws, regulations, ordinances, standards and codes. • Contractor will provide all required traffic control measures and temporary no parking zones for use during pilot test activities. Contractor will furnish and place property safety cones and physical barricades for the prevention of accidents. Traffic control devices, will be, at a minimum, in accordance with applicable state and/or local codes. • Contractor shall rebuild, repair, restore, and make good to the City's satisfaction all damages resulting from Contractor's operations. • Contractor will, upon conclusion of field activities, breakdown and remove all materials and equipment from the site in a timely manner. Contractor will power-wash the asphalt surface if needed to remove residuals. If power washing is performed, Contractor will collect and drum wash water for removal by a disposal company. • Contractor will remove all general refuse from the site for disposal. Task 4 — Utility Clearance • Contractor shall arrange for underground utility locating and clearance prior to site mobilization, and Contractor shall take any and all steps necessary to avoid damaging existing utilities. REV: 10-07-16 JS Page 9 of 13 ATTY/AGR.2016.294/Cascade Drilling - Groundwater Remediation Pilot