AgdaPkt 2017-04-03 Joint SA PFA - Laserfiche WebLink

Browse Search

ATTY/RESO.0031/ CC RESO ADOPTING DENIAL OF APPEAL BY REDWOOD CITY RESIDENTS FOR RESPONSIBLE DEVELOPMENT REV: 03-30-17 PR Page 13 of 22 the design pressure required by Engineering. Upon a final determination by the City that recycled water is available for the property, the applicant shall connect the project to the recycled water system. [SDR][ENGINEERING] 33. Recycled Water Report - The applicant shall hire an engineer licensed in California and experienced in the field of wastewater treatment to prepare a recycled water report for dual plumbed facilities, pursuant to California Water Code section 13522.5 and in accordance with California Code of Regulations sections 60314 and 60323 (found within Title 22, Division 4, Chapter 3). The report shall be submitted prior to project closeout, and will be routed to the Public Works Department for review and coordination. It is recommended a draft of the report is prepared prior to commencing any plumbing work to prevent the need for unplanned changes. [COA] [ENGINEERING] 34. Cross-Connection Control Test - Prior to issuance of the certificate of occupancy, all applicable plumbing systems must pass a cross-connection control test, performed by a Cross-Connection Control Specialist Certified through the CA-NV Section of the AWWA and observed by Public Works staff. The cross-connection control test method must be included in the Recycled Water Report. [COA] [ENGINEERING] 35. Discharge Permit for Subterranean Garages - If the subterranean garage requires groundwater pumping into the sewer system, a Discharge fee will apply and a Discharge Permit will be required by Silicon Valley Clean Water (SVCW) prior to issuance of the building permit. [SDR][ENGINEERING] 36. Backflow Protection – Backflow protection on all water services is required. The backflow preventer shall be above grade and located on private property, accessible to the Public Works division for testing. [COA][ENGINEERING] 37. Fire Flow - The Project shall meet fire flow requirements as established by the Fire Department which are based on the Fire Code. Fire flow tests are typically performed during the preliminary design phase but must be completed prior to submittal of final design. Applicant shall contact the Fire Department for fire flow requirements, and then submit a written fire flow test request to Engineering. [COA][ENGINEERING] 38. C3 Requirements - Plans shall be designed to meet C3 requirements of the Municipal Regional Permit (MRP) NPDES Permit CAS612008 and be in compliance with San Mateo County C.3 Stormwater Technical Guidance. [SDR][ENGINEERING] a. Treatment Controls – Treatment measures to be shown on final improvement or grading plans shall not differ materially from the treatment measures presented on the project’s Tentative Parcel Map, approved on, without written approval from the Engineering Department. b. Treatment Measure Inspection – Applicant shall coordinate installation of stormwater treatment measures with the municipality, shall 8.A. - Page 45