Agmt 19 All Industrial Electrical Supply, Inc.

Browse Search

f. LM -80-08 (Most current), IESNA Approved Method for Measuring Lumen Maintenance of LED Light Sources g. RP -8-00 (Most current), ANSI / IESNA American National Standard Practice for Roadway Lighting h. RP -16-10 (Most current), ANSI/IES Nomenclature and Definitions for Illuminating Engineering i. TM -3-95 (Most current), A Discussion of Appendix E - "Classification of Luminaire Lighting Distribution," from ANSI/IESNA RP -8-83 j. TM-15-11(Most current), Luminaire Classification System for Outdoor Luminaires k. TM -21-11 (Most current), Projecting Long Term Lumen Maintenance of LED Light Sources 5. National Electrical Manufacturers Association (NEMA) a. ANSI/NEMA/ANSLG C78.377-2008 (or latest), American National Standard for the Chromaticity of Solid State Lighting Products 6. National Fire Protection Association (NFPA) a. 70 - National Electrical Code (NEC) 7. Underwriters Laboratories (UL) a. 1449, Surge Protective Devices b. 1598, Luminaires. c. 8750, Light Emitting Diode (LED) Equipment for Use in Lighting Products LED Roadway Specification 8. CSA a. 1598, Luminaires B. GENERAL CONSTRUCTION FOR LED LIGHT FIXTURES AND MOUNTING ARMS 1. LED light fixtures and mounting arms shall be CSA Certified to U.S. Standards and shall comply with ANSI: C136.2, C136.10, C136.14, C136.15, C135.31 and C136.37. 2. Luminaire housing shall be fabricated from die cast aluminum low copper content alloy. a. Luminaire housing shall act as passive heat sink for LED Array. The use of fans or gels is prohibited. b. Housing shall be designed in such a manner that debris build-up with -in "heat - fin" structure will not significantly impact lamp lumen depreciation (LLD). c. Luminaire finish and casting shall be tested to ASTM 13117 salt fog, and must maintain a scribe creepage rating of 7 per ASTM D1654 after 5000 hours. d. Luminaire shall have a hinged doorframe for quick access to internal components. e. Luminaire shall have die-cast trigger latch on doorframe allows for tool -less entry. f. Tool -less access shall accommodate user wearing electrical gloves. g. Weight of fixture shall not exceed 14 lbs. h. EPA of fixture shall not exceed 0.76 Sq. Ft. i. Luminaire shall have rectangular form factor to match existing fixture housing. j. Luminaire configuration shall allow for modular upgradability and/or field repair of all electrical components (i.e. LED modules, Driver(s), etc.). k. Mounting and housing bolts shall be of non -corrosive material. I. Luminaire door shall be made die cast aluminum low copper content alloy with no polycarbonate or fiberglass material. 3. ED light engine a. ED light engines shall be IP66 rated. b. ED light engines shall be a discreet LED array design. No chip on board LED designs are acceptable. c. Lenses shall be created from acrylic to ensure longevity and minimize dirt depreciation. d. ED light engines shall have zero uplight optics reduce sky glow and shall meet Dark Skies requirements. REV: 05-05-2020 MI ATTY/AGR.Amend. No.1/All Industrial Electric Supply, Inc. (Page 4 of 9)