Reso PC19-10 PC Reso 0081 - 1180 Main Project Approval

Browse Search

b. Treatment Measure Inspection — Applicant shall coordinate installation of stormwater treatment measures with the municipality, shall arrange to have the City's designated inspector present at the time of installation, and shall have the City's designated inspector complete a final inspection of installed stormwater treatment measure immediately after installation is complete. 41. Stormwater Management Plan (SWMP) — Applicant shall prepare a SWMP that includes, at a minimum, exhibit(s) showing drainage areas and location of Low Impact Development (LID) treatment measures; total project site area and total area of land disturbed; total new and/or replaced impervious area; treatment measures and hydraulic sizing calculations; a listing of source control and site design measures to be implemented at the site; saturated hydraulic conductivity rate(s) at relevant locations or hydrologic soil type (A, B, C or D) and source of information; elevation of high seasonal groundwater table; and a brief summary of how the project is complying with Provision C.3 of the MRP. [COA][ENGINEERING] 42. Construction General Permit — For construction activity resulting in a land disturbance of one acre or more, applicant shall file a Notice of Intent (NOI) with the State Water Resources Control Board under the Construction Activities Storm Water General Permit (General Permit). The NOI indicates the applicant's intent to comply with the San Mateo Countywide Stormwater Pollution Prevention Program, including a Stormwater Pollution Prevention Plan (SWPPP). [SDR] [ENGINEERING] 43. Stormwater BMPs - Stormwater Pollution Prevention Program Best Management Practices (BMPs) for construction shall be implemented to protect water quality, in accordance with the approved Stormwater Pollution Prevention Plan (SWPPP). BMP plan sheets are available electronically for inserting into project plans. [SDR][ENGINEERING] Street Infrastructure Improvements 44. Green Infrastructure — Provide a stormwater treatment area within the project's Elm Street frontage. The treatment area should be sized to treat the stormwater flows from the entire drainage area (project side of the street from Main St to Lathrop St) based on BASMAA Green Infrastructure Facility Sizing for Non-regulated Street Projects. The treatment area shall be located either within the sidewalk or a maximum 4'-0" curb extension. [COA][ENGINEERING] 45. Streetlights — Traffic scale (cobra -head style) and pedestrian (post -top style) street lights shall be installed along all project frontages within the City right of way. The style location, and spacing of all streetlights shall be as determined by the City Engineer and Planning Manager. [SDR][ENGINEERING] 46. Repair or Replace Street Infrastructure - Restore streets surrounding the project site to the satisfaction of the City Engineer at project completion. When this requires additional pavement restoration, the Engineer shall approve the preferred layout of pavement markings. [SDR][ENGINEERING] 47. Reconstruction of Frontage Streets - The following pavement restoration has been identified for the streets surrounding the project site. The restoration indicated is a minimum requirement and further restoration may be needed if the existing pavement is negatively impacted by the construction of the project: [COA][ENGINEERING] a. Maple Street: Spot repair and micro -surfacing emulsion (MSE) from curb to curb, from Page 19 of 25 ATTY/RESOS/2019/RESO.0081 PC RESO 1180 MAIN PROJECT APPROVAL REV: 07-25-19 PR