Laserfiche WebLink
7.A. - Page 70 of 285 <br />2019 Energy Efficiency Ordinance Cost-effectiveness Study <br />mixed -fuel homes and consulted with contractors to estimate which electricity and/or natural gas services are <br />usually provided to the dryer and oven. Typical practice varied, with some builders providing both gas and <br />electric service to both appliances, others providing both services to only one of the appliances, and some only <br />providing gas. For this study, the Reach Code Team determined that for single family homes the typical cost is <br />best qualified by the practice of providing 220V service and gas to either the dryer and the oven and only gas <br />service to the other. For multifamily buildings it's assumed that only gas is provided to the dryer and oven in the <br />mixed fuel home. <br />It is assumed that no upgrades to the electrical panel are required and that a 200 Amp panel is typically installed <br />for both mixed fuel and all -electric new construction homes. There are no incremental electrical site <br />infrastructure requirements. <br />In-house gas infrastructure (from meter to appliances): Installation cost to run a gas line from the meter to the <br />appliance location is $200 per appliance for single family and $150 per appliance per multifamily apartment <br />based on cost estimates from builders and contractors. The cost estimate includes providing gas to the water <br />heater, furnace, dryer and cooktop. <br />Site gas infrastructure: The cost-effective analysis components with the highest degree of variability are the <br />costs for on-site gas infrastructure. These costs can be project dependent and may be significantly impacted by <br />such factors as utility territory, site characteristics, distance to the nearest gas main and main location, joint <br />trenching, whether work is conducted by the utility or a private contractor, and number of dwelling units per <br />development. All gas utilities participating in this study were solicited for cost information. The typical <br />infrastructure costs for single family homes presented in Table 6 are based on cost data provided by PG&E and <br />reflect those for a new subdivision in an undeveloped area requiring the installation of natural gas <br />infrastructure, including a main line. Infrastructure costs for infill development can also be highly variable and <br />may be higher than in an undeveloped area. The additional costs associated with disruption of existing roads, <br />sidewalks, and other structures can be significant. Total typical costs in Table 6 assume $10,000 for extension of <br />a gas main, $1,686 for a service lateral, and $150 for the meter. <br />Utility Gas Main Extensions rules 15 specify that the developer has the option to only pay 50% of the total cost for <br />a main extension after subtraction of allowances for installation of gas appliances. This 50% refund and the <br />appliance allowance deductions are accounted for in the site gas infrastructure costs under the On -Bill cost- <br />effectiveness methodology. The net costs to the utility after partial reimbursement from the developer are <br />included in utility ratebase and recovered via rates to all customers. The total cost of $5,750 presented in Table <br />6 reflects a 50% refund on the $10,000 extension and appliance deductions of $1,086 for a furnace, water <br />heater, cooktop, and dryer. Under the On -Bill methodology this analysis assumes this developer option will <br />remain available through 2022 and that the cost savings are passed along to the customer. <br />The 50% refund and appliance deductions were not applied to the site gas infrastructure costs under the TDV <br />cost-effectiveness methodology based on input received from the Energy Commission and agreement from the <br />Reach Code technical advisory team that the approach is appropriate. TDV cost savings impacts extend beyond <br />the customer and account for societal impacts of energy use. Accounting for the full cost of the infrastructure <br />upgrades was determined to be justified when evaluating under the TDV methodology. <br />15 PG&E Rule 15: https://www.pge.com/tariffs/tm2/pdf/GAS RULES 15.pdf <br />SoCalGas Rule 20: https://www.socalgas.com/regulatory/tariffs/tm2/pdf/20.pdf <br />SDG&E Rule 15: http://regarchive.sdge.com/tm2/pdf/GAS GAS -RULES GRULE15.pdf <br />17 <br />2019-08-01 <br />322 <br />