My WebLink
|
Help
|
About
|
Sign Out
Browse
Search
Agmt08 ITT Flygt Corporation
RedwoodCity
>
City Clerk
>
Agreements
>
2000-2009
>
2008
>
Agmt08 Under $60K
>
Agmt08 ITT Flygt Corporation
Metadata
Thumbnails
Annotations
Entry Properties
Last modified
3/5/2008 9:49:04 AM
Creation date
3/5/2008 9:36:20 AM
Metadata
Fields
Template:
Agreement
Contractor Name
ITT Industries
PROJECT NAME
Flygt submersible Pump Maintenance, Repair and Servicing
Date
2/27/2008
There are no annotations on this page.
Document management portal powered by Laserfiche WebLink 9 © 1998-2015
Laserfiche.
All rights reserved.
/
15
PDF
Print
Pages to print
Enter page numbers and/or page ranges separated by commas. For example, 1,3,5-12.
After downloading, print the document using a PDF reader (e.g. Adobe Reader).
Show annotations
View images
View plain text
<br />EXHIBIT A (CONT) <br /> <br />~TT Industries <br /> <br />ITT Flygt Corporation <br />790-A Chadbourne Road <br />Fairfield, CA 94534 <br />Tel: (707) 412-9894 <br />Fax: (707) 422-9808 <br /> <br />SCHEDULED PUMP PREVENTATIVE MAINTENANCE INSPECTION AGREEMENT <br />FLYGT CORPORATION <br /> <br />SERVICE - 21 POINT CHECK LIST <br /> <br />tJ Check electrical condition ofinsulation on power cable and on all phases of motor. (In Meg Ohms) <br /> <br />tJ Check for any loose or faulty electrical connections within the pump control pane!. <br /> <br />tJ Measure resistance between stator windings. (In Ohms) <br /> <br />Cl Check voltage supply between all phases of the electrical control panel. (V AC) <br /> <br />Cl Check voltage balance between all phases on the load side'" oftbe pump control with pump on. (V AC) <br /> <br />tJ Check amperage draws on all pbases of the pump motor. (In Amps) <br /> <br />Cl Check condition and operation of motor thermal protectors control system (if so equipped). <br /> <br />Cl Removal ofFlygt pump from lift station for physical inspection. <br /> <br />Q Check condition of upper shaft seals (inspect condition of motor housing). <br /> <br />tJ Check condition and operation of leakage detector (if so equipped). <br /> <br />Cl Check lower shaft seals (inspect condition of oil). <br /> <br />tJ Change oil if needed (cost of oil included). <br /> <br />Cl Check for worn or loose impeller. <br /> <br />tJ Check all impeller wear rings. (Note: Wear rings are not covered by warranty and must be purchased by <br />customer if in need ofreplacement) <br /> <br />o Check for noise upper and lower bearings. <br /> <br />!J Check physically for damage of pump and power cable. <br /> <br />o Clean, reset, and check operation of level sensors. <br /> <br />tJ Check for correct shaft rotation. <br /> <br />tJ Reinstall Flygt pump and check for leakage at the discharge connection. <br /> <br />a Test of pump operation cycle (iflevel ofliquid in station permits). <br /> <br />o Check operating of valves and pipes in station. <br /> <br />F~ <br /> <br />Agreement for Storm System Pump Stations: FIygt Submersible Pump Maintenance, Repair and Servicing <br /> <br />FY 2007-08 <br /> <br />11 <br />
The URL can be used to link to this page
Your browser does not support the video tag.