Agmt21 Bear Electrical Solutions, Inc.

Browse Search

C. Reinforcement for foundations shall be deformed steel bars conforming to the requirements of Section 02550 of the Specifications. Size and shape for bar reinforcement shall conform to the details shown or called for on the plans. 2.04 ELECTROLIERS A. Electrolier masts, arms, fixtures, luminaires and appurtenances shall conform to the details shown on the plans. 2.05 CONTROLLER ASSEMBLIES A. Controller assemblies shall be a Type 90 NEMA Controller Assembly compatible with the City's designated controller system, conforming to Section 86 Electrical Work - General and Section 87 "Electrical System" of the State Standard Specifications including controller unit, completely wired controller cabinet, inductive loop sensor units, conflict monitor, and load switches. B. Cabinets shall be NEMA Type P, TS -2, Type 1. Cabinet shall be prime coated and finished in accordance with Section 91-2 "Paint for Metal" of the State Standard Specification. A graffiti coating acceptable to the City shall then be applied. C. Contractor shall furnish and install battery backup systems in conformance with paragraph 2.21 these Specifications. 2.06 PULL BOXES A. Pull boxes shall be precast reinforced concrete of the size noted or called for on the plans and shall conform to the applicable provisions of Section 86-1.02C "Pull Boxes" and Section 87-1.03C "Installation of Pull Boxes" of the State Standard Specifications with the following exceptions: Grout in the bottom of pull boxes will not be permitted, Contractor shall use drain rock at box sump. 2. Covers for lighting pull boxes shall be marked "Street Lighting" in conformance with the requirements of Section 86-1.02C (1) "General" of the State Standard Specifications. 2.07 CONDUIT A. Conduit shall conform to the provisions in Section 86-1.02B "Conduit and Accessories" and Section 87-1.03B "Conduit Installation" of the State Standard Specifications. B. Conduit for underground electrical circuits shall be Poly Vinyl Chloride (PVC) type 1120, Schedule 40 with solvent weld joints, conforming to ASTM D-1785 and the requirements in the UL Standard for Rigid Non -Metallic Conduit (Publication UL 651). Minimum size conduit shall be 2" diameter. B. Fittings and couplings for underground electrical conduit shall be Poly Vinyl Chloride (PVC), Schedule 40 specifically manufactured for the conduit used. C. Conduit joints shall be solvent weld made by means of "Weld -On" P-70 primer and "Weld - On" cement, or approved equal. D. All empty conduit or conduit for future circuits shall be installed with a 3/16 inch diameter nylon pull rope for future conductor extensions. REV: 12-21-2020 PR ATTY/AGR.2020.306/Bear Electrical Solutions (Page 23 of 35)