Laserfiche WebLink
6.1. -Page 16 of 145 <br />Attachment A <br />ADDITIONAL SPECIFICATION FOR ONE [1] LR7-60RM ARTICULATING OVERCENTER AERIAL DEVICE ON A <br />Item <br />FREIGHTLINER M2-106 CAB CHASSIS <br />Description <br />Model LR7-60RM Articulating Overcenter Aerial Device with an insulating lower <br />boom, insulating upper boom and the ISO -Grip insulating system at the boom tip. For <br />installation over the rear axle and to include the following features: <br />A. Ground to Bottom of Platform Height: 59.6 feet (18.2 meters). <br />B. Working Height: 64.6 feet (19.7 meters). <br />C. Maximum reach to edge of platform with Upper Boom Non- overcenter (working <br />position): 44.8 feet (13.6 meters) at platform height of 27.9 feet (8.5 meters) <br />D. Maximum reach to edge of platform with Upper Boom Overcenter: 48.4 feet (14.8 <br />meters) at platform height of 9.1 feet (2.8 meters) <br />E. Continuous rotation. <br />F. Lower Boom Articulation: 0 to 125 degrees. <br />G. Lower Boom Insulator provides 15 inches (38.1 centimeters) of isolation. <br />H. Upper Boom Articulation: 0 to 270 degrees. <br />I. Platform capacity: 400 lbs (181.44 kilograms) <br />J. Platform leveling: achieved by a single leveling chain and 314" fiberglass rods in <br />the upper and lower booms. This lifetime system is very low maintenance. <br />K. Hydraulic system: Open center (full pressure), maximum flow of 6.0 to 6.5 gpm <br />(22.7 to 24.6 Ipm), maximum operating pressure of 3,000 psi. <br />L. Side -by -Side Boom Stow offers low travel height and easy platform access. <br />M. Maintenance Free Elbow: Nitrided to prevent rust, increase hardness and <br />eliminates the need for grease at the elbow. <br />N. Small Boom Tip Profile. <br />O. Walking link system features uniform speed, smooth and continuous <br />articulation and low maintenance operation. <br />P. Unit is painted with a powder coat paint process which provides a finish -painted <br />surface that is highly resistant to chipping, scratching, abrasion and corrosion. <br />Paint is electrostatically applied to the inside as well as outside of fabricated parts <br />then high temperature cured prior to assembly ensuring maximum coverage and <br />protection. <br />Q. Unit meets or exceeds ANSI 92.2 standards. <br />2. Manual Upper Boom Stow Securing System with support cradle and tie down strap <br />Page 13 of 23 <br />Bidder's Initials <br />QtV <br />187 <br />