Ord 2542 - Laserfiche WebLink

Browse Search

ATTY/ORD.0010/CC ORD AMENDING MUNI CODE CH.18, 27A, 30 – EXHIBIT C REV: 09-17-24 VR Page 61 of 65 3. The parcel map conforms to the applicable objective zoning standards, subdivision standards, and design review standards, including those identified in this Section, and objective requirements of the Subdivision Map Act (commencing with Government Code Section 66410), except as otherwise expressly provided in Government Code Section 66411.7 as may be amended from time to time; provided however, that the City shall waive or modify any standard if the standard would have the effect of physically precluding the construction of two (2) units on either of the resulting lots or would result in a unit of less than eight hundred (800) square feet. Any modifications of development standards shall be the minimum modification necessary to avoid physically precluding two (2) units of eight hundred (800) square feet on each lot. Notwithstanding, required rear and side yard setbacks shall equal four (4) feet, except that no setback shall be required for an existing legally created structure or a new structure constructed in the same location and to the same dimensions as an existing legally created structure.4.The lot has not been established through prior exercise of an urban lot split as provided for in this Section or Government Code Section 66411.7 as may be amended from time to time. D. Lot Design Standards. All urban lot splits shall comply with the following lot design standards: 1. Both lots resulting from the urban lot split shall have access to, provide access to, or adjoin the public right-of-way through right-of-way frontage or recorded access easements. 2. Lot depths shall not exceed two and one-half (2½) times their average width. 3. No lot created under this Chapter shall be divided by a City boundary line. 4. No lot created under this Chapter in a residentially zoned district shall have a double frontage except in the case of a corner lot. 5. Each newly created lot shall be no smaller than one thousand two hundred (1,200) square feet. E. Panhandle Lots. Urban lot splits that create panhandle lots shall meet the following requirements: 1.The handle section of lot shall have a width of no less than fifteen (15) feet. 2. A primary dwelling unit shall be located within two hundred (200) feet from the street frontage of such lot. 3. The average lot width zoning requirements shall only apply to the pan of the lot and not to the handle leading from the required frontage.