Reso 23-21 0097 PC23-21 PC Reso 1 Twin Dolphin

Browse Search

ATTY/RESO.0097/PC RESO 1 TWIN DOLPHIN REV: 10-04-23 VR Page 16 of 23 at the design pressure required by Engineering. Upon a final determination by the City that recycled water is available for the property, the applicant shall connect the project to the recycled water system. Pipe material for internally dual plumbed systems intended for the conveyance of recycled water shall be constructed of non-metallic materials as allowed in the California Plumbing Code, and in accordance with the City’s Customer Guidelines for Recycled Water Use. [COA][ENGINEERING] 40. Recycled Water Report - The applicant shall enter into a Recycled Water Use Agreement and shall hire an engineer licensed in California and experienced in the field of wastewater treatment to prepare a recycled water report for dual plumbed facilities, pursuant to California Water Code section 13522.5 and in accordance with California Code of Regulations sections 60314 and 60323 (found within Title 22, Division 4, Chapter 3). The first draft of the report and the signed agreement shall be submitted to Engineering prior to building permit issuance, and will be routed to the Public Works Department for review and coordination. [COA] [ENGINEERING] 41. Cross-Connection Control Test - Prior to issuance of the certificate of occupancy, all applicable plumbing systems must pass a cross-connection control test, performed by a Cross-Connection Control Specialist Certified through the CA-NV Section of the AWWA and observed by Public Works staff. The cross-connection control test method must be included in the Recycled Water Report. The applicant is responsible for all fees associated with the performance of the cross-connection control test. [COA] [ENGINEERING] 42. Backflow Protection – Backflow protection on all water services is required. The backflow preventer shall be above grade and located on private property, accessible to the Public Works division for testing. [COA][ENGINEERING] 43. Fire Flow - The Project shall meet fire flow requirements as established by the Fire Department which are based on the Fire Code. Fire flow tests are typically performed during the preliminary design phase but must be completed prior to submittal of final design. Applicant shall contact the Fire Department for fire flow requirements, and then submit a written fire flow test request to Engineering. [COA][ENGINEERING] 44. C3 Requirements - Plans shall be designed to meet C3 requirements of the Municipal Regional Permit (MRP) NPDES Permit CAS612008 and be in compliance with San Mateo County C.3 Stormwater Technical Guidance. [SDR][ENGINEERING] a. Treatment Controls – Treatment measures to be shown on final improvement or grading plans shall not differ materially from the treatment measures presented on the project’s Vesting Tentative Parcel Map, dated September 19, 2023, without written approval from the Engineering Department. b. Treatment Measure Inspection – Applicant shall coordinate installation of stormwater treatment measures with the municipality, shall arrange to have the City’s designated inspector present at the time of installation, and shall have the City’s designated inspector complete a final inspection of installed stormwater treatment measure immediately after installation is complete.