Laserfiche WebLink
REV: 04-29-25 LF <br />DOOR LOCK LH EMS COMPARTMENT <br />The left hand side EMS compartment shall feature a power door lock actuator. <br />DOOR LOCK RH EMS COMPARTMENT <br />The right-hand side EMS compartment shall feature a power door lock actuator. <br />POWER DOOR LOCK COMPARTMENT ACTIVATION <br />The power door lock feature shall include activation for exterior compartment door locks through <br />the key fob, keypads and through a rocker switch on the switch panel. <br />GRAB HANDLES <br />The cab shall include one (1) 24.00 inch three-piece knurled aluminum, anti-slip exterior assist <br />handle, installed behind each cab door. The assist handle shall be made of extruded aluminum <br />with a knurled finish to enable non-slip assistance with a gloved hand. <br />AUXILIARY GRAB HANDLE <br />There shall be two (2) 7.00 inch molded stainless steel grab handles with a bright finish attached <br />to the front fascia of the cab one (1) each side above the headlights. <br />REARVIEW MIRRORS <br />Moto Mirror model 7-2386 Traditional west coast style mirrors shall be provided on the driver’s <br />and officer’s doors. <br />The mirrors shall be mounted to the cab doors with tubular stainless steel, swing away arms and <br />shall measure 7.00 inches wide X 16.00 inches high. The mirrors shall be heated and remote <br />control with side to side movement actuation. The mirror control switches shall be located within <br />easy reach of the driver. The mirrors shall be constructed with stainless steel housings and shall <br />include two (2) 8.00 inch diameter convex mirrors below the mirror head further increasing <br />visibility. <br />The mirrors shall include the finest quality non-glare glass and shall include a rigid mounting <br />reducing vibration. Both mirrors shall be corrosion free under all weather conditions. <br />REARVIEW MIRROR HEAT SWITCH <br />The heat for the rearview mirrors shall be controlled through a rocker switch on the dash in the <br />switch panel. <br />EXTERIOR TRIM REAR CORNER <br />There shall be mirror finish stainless steel scuff plates on the outside corners at the back of the <br />cab. The stainless-steel plate shall be affixed to the cab using two-sided adhesive tape. <br />ATTY/AGR.2025.089/Fire Apparatus Solutions (Purchase of Spartan-LTC 105' TDA) (Page 67 of 150)