Res12 15209 - Laserfiche WebLink

Browse Search

09/10/2012 back as far as necessary to achieve the sidewalk widths required for the applicable Corridor Type, with the exception that such setbacks will not be permitted or required to exceed the maximum setbacks set forth in Section 2.6. In this case, part of the Private Frontage area may also satisfy the Public Frontage requirements of this section. The Set Back method shall not be required if it necessitates the demolition of existing structures which are within the necessary setback area, and which are not intended to be removed as part of the proposed project. Section 13. Section 2.8.3-C-2 is hereby amended to read as follows: 2, Guidelines a. The Building Base Length Articulations should be created using a pilaster. Building Base Pilasters should have the following characteristics: • The horizontal width of a protruding pilaster or pier should be at least 18 inches wide, but should not exceed 4 feet in width. • The depth of the protruding pilaster should be at least 12 inches � of+ho r�il�c4or��iirl�h /cco R��ilrlir�ir R�co Dil�c•�or �_`r�r�hin\ • A Plinth treatment, as described above. • A cap treatment, such as a darker color, a visible thickening, a crown mold, or a column capital. Section 14. Section 2.8.3 is hereby amended to add the following subsection (F) after subsection (E): F) General Private Frontage Regulations 1. Standards a. All street-facing or public open space-facing portions of the ground floor fa�ade between Building Base Length Articulation elements shall be known as a Building Base Bay. Each Building Base Bay shall have one designated Private Frontage type. One Building Base Bay may not be divided between two Frontage Types, establishments, or dwelling units. b. A property's permitted Private Frontage Types are determined by Corridor Type as shown within the Fa�ade Composition Regulation Chari: All permitted Frontage Types for a single ATTY/RES0.2269/RESOLUTION FOR AMENDMENT TO DTPP RESO.#15209 REV:08-14-12 PT MUFF#613 Page 14 of 20