Laserfiche WebLink
4. Serial no. <br /> 5. Date of manufacture (month-year) <br /> 6. Lot number <br /> 7. Contract number <br /> 8. Rated voltage <br /> 9. Rated wattage <br /> 10. Rated power in VA <br /> Electrical <br /> The luminaire must operate from a 60 ±3 Hz AC power source. The fluctuations of line voltage <br /> must have no visible effect on the luminous output. The operating voltage must range from 95 to 277 <br /> V(ac). The operating voltages for this option are 120 V(ac) and 240 V(ac). <br /> The power factor of the luminaire must be 0.90 or greater. Totai harmonic distortion, current <br /> and voltage, induced into an AC power line by a luminaire must not exceed 20 percent. The maximum <br /> power consumption allowed for the luminaire must be as shown in the following table: <br /> Application Maximum Consumption <br /> W atts <br /> Roadwa 1 165 <br /> Roadwa 2 235 <br /> Roadwa 3 235 <br /> Roadwa 4 300 <br /> Surge Suppression and Electromagnetic Interference <br /> The luminaire on-board circuitry must inc�ude an SPD to withstand high repetition noise <br /> transients caused by utility line switching, nearby lightning strikes, and other interferences. The SPD <br /> must protect the luminaire from damage and failure due to transient voltages and currents as defined in <br /> Tabies 1 and 4 of ANSI/IEEE C64.41.2 for location category C-High. The SPD must comply with UL <br /> 1449. The SPD performance must be tested under ANSI/IEEE C62.45 based on ANSI/IEEE C62.41.2 <br /> definitions for standard and optional waveforms for location category C-High. <br /> The luminaires and associated on-board circuitry must comply with the Class A emission limits <br /> provided in 47 CFR 15, subpart B concerning the emission of electronic noise. <br /> Compatibility <br /> The luminaire must be operationally compatible with currently used lighting control systems and <br /> photoelectric controls. <br /> Photometric Requirements <br /> The luminaire must maintain a minimum illuminance level throughout the minimum operating <br /> life. The L70 of the luminaire must be the minimum operating life or greater. The measurements must <br /> be calibrated to standard photopic calibrations. The minimum maintained illuminance values, <br /> measured at a point, must be as shown in the following table: <br /> SPECIAL CONDITIONS 00800-9 <br /> EAST BAYSHRORE ROAD STREET LIGHTING PROJECT <br />