Ord 2401 - Laserfiche WebLink

Browse Search

01/13/2014 the SBWMA has included in its list of recognized Certified C&D Debris Recycling Facilities. The SBWMA shall include in its list of Certified C&D Debris Recycling Facilities only those facilities whereby the owner or operator of the facility submits documentation to satisfactorily confirm to the SBWMA: 1. That the facility has obtained all applicable Federal, State, and local permits, and is in full compliance with all applicable regulations; and 2. The percentage of incoming waste from construction, demolition, and alteration activities that is diverted from landfill disposal meets the required minimum percentage set forth in the standards recognized by the SBWMA. If available, the City will provide to each building permit applicant paying a diversion deposit a current list of SBWMA Certified C&D Debris Recycling Facilities. Sec. 9.195. - Information Required Before Issuance of Permit: WASTE MANAGEMENT PLAN: Applicants for projects affected under this Article shall submit a properly completed "Waste Management Plan" (WMP) on a form(s) provided by the City, and shall submit the form(s) to the City's Community Development Department, as a part of the building or demolition permit process. A) Prior to issuance of any building or demolition permit, Applicants must submit a complete and accurate WMP which then must be approved by the Chief Building Official or designee. The WMP must accurately estimate the tonnage of C&D Debris to be generated from the project and provide other information regarding the ApplicanYs plans for diverting materials generated by the Covered Project. B) The Chief Building Official or designee may require the Applicant to include in the WMP the following information: (1) the estimated volume or weight by material type of the Covered Project's C&D Debris, to be generated; (2) the estimated maximum volume or weight of such materials that can feasibly be diverted via reuse or recycling; (3) the vendor or facility that the Applicant proposes to use to collect or receive that material; (4) the estimated project completion date; and, (5) the estimated volume or weight C&D Debris that will be ultimately disposed of in a landfill or incinerator. In estimating the volume or weight of materials identified in the WMP, the Applicant shall use the Standardized Conversion Rates approved by the City for this purpose. ATTY/ORD.396/C&D ORD ADDING ARTICLE XI ORD.#2401 REV:11-26-13 MLG FORMERLY MUFF#305 Page 8 of 13