AgdaPkt 2016-02-22 Closed and Interview and Joint SA PFA

Browse Search

Safety Data Sheet Material Name: Copper Sulfate Pentahydrate * * * Section 14-T ransportation Informatio n Air* * * 55111 E dition lnternational A i•· Tran spo11 Association (lATA): ID: Cl-121A For Shipments by Air transport: This infonnation applies to air sh.ipments both within the U.S. and for shipments originating in the U.S., but being shipped to a different country. UN/NA #: UN 3077 Prop er S hipp ing Name: Environmentall y Hazardous Substance, sol id , n.o .s. (cupric s ulfate) Hazard C lass: 9 (Miscell aneous Dangerous Goods) Packing G•·o up: III Passenger & Cargo A ircraft Packing lostru c tio11: 956 Pass enge•· & Car go Aircraft Maximum Net Quantity: 400 kg Limited Quantity Packing Instru ction (Passenger & Car go A irc raft): Y956 Limited Quantity Maximum Net Quantity (Passenger & Cargo Aircraft): 30 kg G Excepted Quantities: El Excepted Quantity Maximum inn e r package: 30g Excepted Quantity Maximum outer p a clmge: I kg Cargo Aircraft Onl y Pacldng Instruction: 956 Car go A ircraft Only Maximum Net Quantity: 400 leg Special Provisions: A97, A158, Al79 A 197 ERG: 9L L imited Quantity S hipments: Shipm e nts for air must be marked with the Proper Shippin g Name and UN # shall on the package. The top and bottom portions of the square-on-point must be black and the center w h ite or of a suitable contrastillg backgroulld and the symbol "Y" must be black and located in the center of the square-on-point. The ma rk must be at least 2 mm . Each side must have a minimum dimension of I 00 mm. Small packages which cannot reason ab ly accommodate a I 00 mm sq uare-on-point mark may be marked with a square -on-point mark with a minimum s id e dimension of 50 rnm.The total weight of each ou ter packaging cannot exceed 30 kg. Excepted Quantities: The max.imum quantity of t hi s material per inner receptacle is limited to 30 g per receptacle and the aggregate quantity of this material per completed package does not exceed 1 kg. The inner receptacles must be secu rely packed in an intermediate packaging with cushioning material to prevent moveme nt in the inner recept acles and packed in a strong o uter box w ith a g ross mass not to exceed 29kg. The co mpleted package must meet a drop test. The requirements a re found in 2.7.6.1. The package must not be opened o r otherv•ise altered unti l it is no longer in commerce . For ail· transportation no shipp ing paper is required. The package must be legibly marked w ith the tbl lowing marking: NOTE: The "" must be replaced by the primary hazard dass, or when assigned, the division of each of the hazardous materials contained in the package. The "~" must be replaced by the name of the shipper or consignee if not shown elsewhere on the package. The symbol shall be not less than 100 mm x 100 mm and must be durable and clearly visible. Issue Date: 09/09/98 13:25:58 CLW Page II of l 4 Revision Date: Ol /14/2015 13:00 CST 6.3.A. - Page 146