Laserfiche WebLink
Cross-Connection Control Specialist Certified through the CA-NV Section of the AWWA <br /> and observed by Public Works staff. The cross-connection control test method must be <br /> included in the Recycled Water Report. [COA] [ENGINEERING] <br /> 51. Backflow Protection — Backflow protection on all water services is required. The <br /> backflow preventer shall be above grade, and shall be located on private property, <br /> accessible to the Public Works division from the outside for testing. <br /> [COA][ENGINEERING] <br /> 52. Fire Flow - The Project shall meet fire flow requirements as established by the Fire <br /> Department which are based on the Fire Code. Fire flow tests are typically performed <br /> during the preliminary design phase but must be completed prior to submittal of final <br /> design. Applicant shall contact the Fire Department for fire flow requirements, and then <br /> submit a written fire flow test request to Engineering. [COA][ENGINEERING] <br /> 53. C3 Requirements - Plans shall be designed to meet C3 requirements of the Municipal <br /> Regional Permit (MRP) NPDES Permit CAS612008 and be in compliance with San <br /> Mateo County C.3 Stormwater Technical Guidance. [SDR][ENGINEERING] <br /> a. Treatment Controls—Treatment measures to be shown on final improvement <br /> or grading plans shall not differ materially from the treatment measures <br /> presented on the project's Vesting Tentative Parcel Map, approved on August <br /> 16, 2016, without written approval from the Engineering Department. <br /> b. Treatment Measure Inspection — Applicant shall coordinate installation of <br /> permanent stormwater treatment measures with the municipality, shall arrange <br /> to have the City's designated inspector present at the time of installation, and <br /> shall have the City's designated inspector complete a final inspection of <br /> installed stormwater treatment measure immediately after installation is <br /> complete <br /> 54. Stormwater BMPs - Stormwater Pollution Prevention Program Best Management <br /> Practices (BMPs) for construction shall be implemented to protect water quality, in <br /> accordance with the approved Stormwater Pollution Prevention Plan (SWPPP). BMP <br /> plan sheets are available electronically for inserting into project plans. <br /> [SDR][ENGINEERING] <br /> 55. Stormwater Management Plan (SWMP) — Applicant shall prepare a SWMP that <br /> includes, at a minimum, exhibit(s) showing drainage areas and location of Low Impact <br /> Development (LID) treatment measures; total project site area and total area of land <br /> disturbed; total new and/or replaced impervious area; treatment measures and hydraulic <br /> sizing calculations; a listing of source control and site design measures to be <br /> implemented at the site; saturated hydraulic conductivity rate(s) at relevant locations or <br /> hydrologic soil type (A, B, C or D) and source of information; elevation of high seasonal <br /> groundwater table; and a brief summary of how the project is complying with Provision <br /> C.3 of the MRP. [COA][ENGINEERING] <br /> Street Infrastructure Improvements <br /> ATTY/RESO.0075/PC RESO 1629 MAIN STREET(BUTLER) <br /> REV:08-16-16 VR Page 12 of 22 <br />