Agmt95 Metricom - Laserfiche WebLink

Browse Search

METRIC OM shall comply with all applicable laws, ordinances, codes and regulations of the federal, state and local governments in connection with the work and SERVICES to be provided by METRIC OM pursuant to this AGREEMENT. PART II· CONSTRUCTION Section 1. PLANS AND SPECIFICATIONS. METRIC OM has submitted to the Community Development Department of CITY and CITY has approved certain plans and specifications for the PROJECT attached hereto as EXHIBIT "C," entitled "PLANS AND SPECIFICATIONS," and incorporated fully herein by this reference. METRICOM agrees to perform any work of the PROJECT at METRICOM's sole cost and expense and in accordance with and in a manner that the City Engineer (the "ENGINEER"), or the ENGINEER's designee, is satisfied conforms to the PLANS AND SPECIFICATIONS. Approval by CITY of the PLANS AND SPECIFICATIONS shall not release METRIC OM from the responsibility for or the correction of any errors, omissions or other mistakes that may be contained in the PLANS AND SPECIFICATIONS. Section 2. SCHEDULE OF PERFORMANCE. A. All work to be performed by METRIC OM under this agreement shall be commenced and completed in accordance with a mutually agreeable time schedule. B. METRICOM shall obtain all applicable permits and notify the Engineering Division of the Community Development Department of CITY at (415)780-7380 or other telephone number for that Division, at least forty-eight (48) hours but not more than one (1) week: (1) prior to the commencement of each phase of work to be performed by METRICOM under this AGREEMENT; (2) prior to resuming work under this AGREEMENT after an interruption in work that continues for more than two (2) working days; (3) prior to changing any component of the work schedule set forth in the SCHEDULE OF PERFORMANCE applicable to work to be performed by METRIC OM under this AGREEMENT; and (4) prior to canceling any work or the completion of any work to be performed by METRIC OM under this AGREEMENT. C. Notwithstanding PART I, SECTION 1, ENGINEER shall have the authority to modify the PLANS AND SPECIFICATIONS and the SCHEDULE OF PERFORMANCE to: (1) Change the pole locations listed on the PLANS AND SPECIFICATIONS; and (2) Change the number of poles listed on the PLANS AND SPECIFICATIONS to add pole locations, up to a maximum number equal to twenty percent (20 of the pole locations listed on the PLANS AND SPECIFICATIONS on the Execution Date, or to subtract pole locations, up to a maximum number equal to twenty percent redwood3.doc 5 9/21/95 · ....... I