Reso PC17-15 0095 PC Reso 601 El Camino

Browse Search

Works Department for review and coordination. It is recommended a draft of the report is prepared prior to commencing any plumbing work to prevent the need for unplanned changes. [COA] [ENGINEERING] 27. Cross -Connection Control Test - Prior to issuance of the certificate of occupancy, all applicable plumbing systems must pass a cross -connection control test, performed by a Cross -Connection Control Specialist Certified through the CA -NV Section of the AWWA and observed by Public Works staff. The cross -connection control test method must be included in the Recycled Water Report. The applicant is responsible for all fees associated with the performance of the cross -connection control test. [COA] [ENGINEERING] 28. Backflow Protection — Backflow protection on all water services is required. The backflow for domestic water services serving a single unit shall be provided by a check valve within the meter assembly. All other services require a separate backflow preventer. The backflow preventer shall be above grade and located on private property, accessible to the Public Works division for testing. [COA][ENGINEERING] 29. Fire Flow - The Project shall meet fire flow requirements as established by the Fire Department which are based on the Fire Code. Fire flow tests are typically performed during the preliminary design phase but must be completed prior to submittal of final design. Applicant shall contact the Fire Department for fire flow requirements, and then submit a written fire flow test request to Engineering. [COA][ENGINEERING] 30. C3 Requirements - Plans shall be designed to meet C3 requirements of the Municipal Regional Permit (MRP) NPDES Permit CAS612008 and be in compliance with San Mateo County C.3 Stormwater Technical Guidance. [SDR][ENGINEERING] a. Treatment Controls — Treatment measures to be shown on final improvement or grading plans shall not differ materially from the treatment measures presented on the project's Vesting Tentative Map, approved on October 17, 2017, without written approval from the Engineering Department. b. Treatment Measure Inspection — Applicant shall coordinate installation of stormwater treatment measures with the municipality, shall arrange to have the City's designated inspector present at the time of installation, and shall have the City's designated inspector complete a final inspection of installed stormwater treatment measure immediately after installation is complete. 31. Stormwater Management Plan (SWMP) — Applicant shall prepare a SWMP that includes, at a minimum, exhibit(s) showing drainage areas and location of Low Impact Development (LID) treatment measures; total project site area and total ATfY/RESO.0095/PC RESO 601 EL CAMINO REV: 10-18-17 PR Page 12 of 16