Laserfiche WebLink
<br />shall be set at a pressure of not more than 125 pcmnds <br /> <br />per square inch. <br /> <br />" , (e) <br /> <br />Relief v'alves located inside a building <br /> <br />shall be provided with a full size drain of galvanized <br /> <br />steel or hard drawn copper piping and fitt.ings and <br /> <br />shall extend from the valve to the out.side of the <br /> <br />building with the end of the pipe not more than two <br /> <br />feet nor less t,han six inches above the ground and <br /> <br />pointing down\'Jard. Such drain may terminat.e at other <br /> <br />approved locations. No part of such drain pipe shall <br /> <br />be trapped and the ter-minal end of the drain pipe shall <br /> <br />not be threaded. <br /> <br />.., (f) Any water heating device connected to a <br /> <br />separate storage tank and having valves between said <br />heater and tank shall be provided ''lith a water. pressure <br /> <br />relicf valve. <br /> <br />" '(g) Nothing contained herein shall prevent the <br /> <br />use of an approved co~bination temperature and pressure <br /> <br />relief valve. Each such approved combinat.ion temperat.ure <br /> <br />and pressure relief valve shall be installed on the <br /> <br />water heating device in an approved location based on <br /> <br />its listing requirements and the manufacturer's - <br /> <br />instructions. Each such combination temperature and <br /> <br />pressure re1i.ef valve shall be provided with a drain <br /> <br />as requir.ed in subsection (e) of this section. <br /> <br />"Section 9.90 <br /> <br />section 1107.1 is hereby added to <br /> <br />the Plu111Ring Code to read as follows: <br /> <br />"'Section 1107.1 <br /> <br />W'h~n a ma in sel.'ler is located <br /> <br />in the street, alley or easement, there must be provided <br /> <br />a cleanout bl-ought up flush with sidewalk level at the <br /> <br />-5- <br /> <br />T" <br />