Agmt 19 All Industrial Electrical Supply, Inc.

Browse Search

c. Luminaire shall provide means to protect LED driver and LED fighting array from electrical transients caused by electrical storms or capacitor switching by means of surge protection device. i. Surge Protection Device (SPD) shall be UL1449 recognized. ii. SPD shall be 3 wires and provide both common and differential mode protection. iii. SPD must have an inductive filter circuit that reduces the amount of energy passed thru to electronics during a surge event. iv. Surge protection device shall be rated to protect the luminaire up to 5kV/10kA combination wave surges in accordance with ANSI C136.2 (Most Current). V. Surge protection shall be thermally fused. Vi. Failure mode of surge protection shall to leave luminaire off. vii. The use of a MOV Pack Surge Protection device that fails and leaves the luminaire on is strictly prohibited. d. LED Driver shall meet the following minimum requirements: I. LED Driver shall have a minimum power factor of 90% at full load. if. LED Driver THD shall be less than 20% at full load per ANSI C82.77:2002. iii. LED Driver shall comply with the requirements of UL, CSA, FCC Title 47 subpart 15. iv. LED Driver maximum case temperature shall not be exceeded when luminaire is operating in a 40C ambient. V. LED Driver shall be RoHS compliant. Vi. LED Driver shall have in ingress protection rating IP66. vii. LED Driver shall have input voltage range of 120-277 +-10%. viii. LED Driver shall of a life rating of less than .5% failure rate at 100,000 operating hours (at full rated power and operating ambient temperature of 25 degrees C). ix. Upon receiving a 0-10V signal, LEDs shall dim down to at least 10% power. Driver must include leads to accept a 0-10V signal. e. Photocontrol receptacle shall comply with ANSI C136.41 for standard 7 PIN configurations. The 7pin photocontrol receptacle shall be accessible, installed and prewired in each luminaire. I. Luminaire shall include a long life solid-state locking -style photo control with a 20 - year rated life and a minimum 10 -year warranty. ii. DESIGN DETAILS a) LED inrush protection with triac assisted relay b) Extreme surge protection of 1280J/40kA utility or 2120J/40kA UL listed c) Double thick enclosure and lens with additional UV inhibitor d) High Temperature base plastic tested to 140°C e) Long life capacitors f) Full wave rectified power supply g) Dual zener diodes for long life h) Solid brass contact blades I) Double sided, thru hole plated .062" FR4 circuit board j) Conformal coated printed circuit board k) Sealed packaging for extended storage iii. REGULATORY LISTINGS a) ANSI C136.10 b) ROHS compliant c) UL listed to U.S. and Canadian safety standards Page 9 of 13 REV =Rt�$7%F°C 2019.059/All Industrial Electric Supply, Inc./LED Street Lights