Reso PC19-11 PC Reso 0084 55 Perry

Browse Search

b. Work requiring a grading permit. Grading permits require a Plot and Finished Grading Plan prepared by a California -registered Civil Engineer. c. Work requiring on-site shoring which affects the public right of way d. Work using the public right-of-way for any fixed structure (awnings, roof overhangs, fixed planters, etc.). Insurance, meeting the City's standards, is required. This permit will be recorded against the property. 15. Undergrounding Utilities -If needed, as determined by the City Engineer, the applicant shall underground all overhead utility services connected to the building and shall be shown on the building permit plans. [CCA] [ENGINEERING] 16. Sewer Lateral Limit - The project is limited to one sewer lateral per parcel. [COA] [ENGINEERING] 17. Sewer Lateral Size for Commercial Development - For new or remodeled commercial buildings, sewer laterals less than 4" shall be upgraded to a minimum 6" size. [SDR] [ENGINEERING] 18. Water Mains - Prior to encroachment permit issuance, submit to City, and obtain approval of, an evaluation and report, prepared by a licensed engineer, in conformance with the City's Engineering Standards, demonstrating that the proposed water main meets the domestic and fire flow requirements in accordance with City Code Section 38.26 and the International Fire Code. If the existing water main is less than 6" in size, or is in any other way not sufficient as determined by the City Engineer, applicant shall, as part of the Project, construct and install new water mains sufficient to meet such requirements, in accordance with the City's Engineering Standards and as directed by the City Engineer. New water mains shall be 8" minimum in size and extend across the entire property frontage, from the nearest point of connection to an existing 6" or larger water main.[SDR] [ENGINEERING] 19. Water Meters - The project is limited to one "master" water meter for domestic water service. Any metering for individual units must be accomplished by private sub -meters within the property. [COA][ENGINEERING] 20. Backflow Protection - Backflow protection on all water services is required. The backflow preventer shall be above grade and located on private property, accessible to the Public Works division for testing. [COA][ENGINEERING] 21. Fire Flow - The Project shall meet fire flow requirements as established by the Fire Department, which are based on the Fire Code. Fire flow tests are typically performed during the preliminary design phase but must be completed prior to submittal of final design. Applicant shall contact the Fire Department for fire flow requirements, and then submit a written fire flow test request to Engineering. [COA] [ENGINEERING] 22. Stormwater BMPs - Stormwater Pollution Prevention Program Best Management Practices (BMPs) for construction shall be implemented to protect water quality, in accordance with the approved Stormwater Pollution Prevention Plan (SWPPP). BMP plan sheets are available electronically for inserting into project plans. [MR] [ENGINEERING] Street Infrastructure Improvements 23. Streetlights -The existing streetlight within the project frontage on Perry Street shall be protected in place and refurbished as apart of the project. [SDR] [ENGINEERING] Page 7 of 9 ATTY/RESO.0084/PC RESO 55 PERRY REV: 08-22-19 PR