Laserfiche WebLink
6.E. - Page 65 of 97 <br />The body will be installed on a 2019/ new Freightliner M2 106 single rear axle chassis with a <br />Cummins 6.7 L300 HP diesel engine, automatic transmission, 108" CA, air brakes, 33,000 Ib. gvwr. <br />The Dump Body specifications are as follows: <br />Sample photo only, completed vehicle may vary. <br />• Body Length (ft.): 12, Body Id (inch): 84, Body OD: 96 <br />• Hoist Model: * 1824HD <br />• Hydraulics: * Direct mount with air shift controls and dump limit valve <br />• Understructure: * 3/16" Hi -Ten steel, fabricated trapezoid, fully boxed 14" long <br />members <br />• Understructure Spacing: N/A - Cross -member less <br />• Yardage:8 <br />• Front Height (inches): * 46, Side Height (inches): 30, Tailgate Height (inches): <br />38, Front Material: * 10 GA steel, Side Material: * 10 GA Steel, Tailgate <br />Material: * 3/16" steel, Floor Material: * 1/4" steel plate AR400 <br />• Side Bracing: One full length self-cleaning horizontal side brace <br />• Rear Corner post Width: 10 <br />• Tailgate Release: * Air/Air with over center installed <br />• Tailgate Hardware: 3/4" flame cut offset TG hinge <br />• Sliding Doors (3): * Pull Down, Sliding Door Location: * Left/Center/Right <br />• Front Pillar: Tapered Front Pillar <br />• SS/Cor-Ten Rear Pillar: * 3/16" Hi -Ten <br />• Cab Shield: * 1/2 size, TOGA. <br />• Spill Apron: 10" <br />• Back-up alarm/ body raise ind. <br />• LED lights and lighting per DOT standard <br />• Reservoir <br />• Hyd pump/ valve kit <br />• Body prop kit <br />291 Page <br />275 <br />