Laserfiche WebLink
6.G. - Page 62 of 124 <br />ATTACHMENT B <br />October 14, 2020 <br />A 55 Gallon DOT approved diesel transfer tank with a Fill -Rite FR 1210 pump and 50 FEET OF 3/W' <br />dispensing hose, meter, and a manual nozzle will be provided and installed in the cargo area. <br />A PR035H Honda 35 CFM skid piatform 11 HP, electric start 35 CFM cr 100 PSI, max 175 PSIG Air <br />Compressor (2) 4 gallon air tanks will be provided and installed in the cargo area. A remote start/stop will be <br />installed at the curbside rear of the truck body. <br />120 VAC System: <br />A Vanner IT12 3600 120 volt inverter will be provided and installed with two dedicated batteries in the <br />streetside rear compartment. <br />A 12 volt bi-directional battery separator shall be included in the system. <br />Waming Lights: <br />Six (6) surface mounted LED amber flashing lights will be installer) on the truck as follows: Two (2) at the front, <br />two (2) at the rear. and one (1) on the left and right side of the body. <br />A Federal Signal Model SL85A Traffic Advisor 1 equivalent will be provided and installed at the back of the cab <br />on the headboard facing the rear of the truck. <br />Work Lights: <br />One (1)12 volt worklight will be installed on the crane and controlled by a switch located on the crane pedestal. <br />Two (2)12 volt Federal Signal Model COM750-RNO LED lights with swivel mounts will be installed on the left <br />and right sides at the rear of the truck. These lights will be controlled by a switch located inside the cab. <br />Two (2) Whelen Pioneer Pius Series 12 Volt LED ! equivalent combination flood — spotlights with telescoping <br />poles will be provided and installed on the front left and right sides of the truck body. Lights will have onloff <br />switches mounted on the light head. <br />Height Restriction: (To be discussed during the Pre -Construction Meeting) <br />MAXIMUM OVERALL HEIGHT OF THE VEHICLE SHALL NOT EXCEED 7 FEET 3 Y". <br />Paint and finish: <br />Body exterior and compartment interiors to be painted white to match the cab <br />All surfaces to be acid etched, cleared of rust, grease, oil, dirt, millscale, etc., prior to the prune coat of <br />paint. <br />All exterior and interior surfaces coated With minimum two coats of metal primer Body exterior painted <br />with minimum two coats paint to match cab <br />Body compartment interiors painted with a minimum two coats of white paint. <br />• Page 6 <br />310 <br />