Laserfiche WebLink
6.G. - Page 78 of 124 <br />Leaf spring suspension reinforcement for the crane will be provided. <br />A third party OA OSHA Certificate will be provided. <br />Manual inlout outriggers will be installed on the truck. <br />A boom rest will be installed on the passenger side at the front of the truck. <br />120 VAC System. <br />ATTACHMENT B <br />October 14, 2020 <br />A Vanner IT12 3600 120 volt inverter will be provided and installed with two dedicated batteries in the <br />streetside rear compartment. <br />A 12 volt bi-directional battery separator shall be included in the system. <br />Wamin9 Liights: <br />Six (6) surface mounted LED amber flashing lights will be installed on the truck as follows: Two (2) at the front, <br />two (2) at the rear, and one (1) on the left and right side of the body= <br />A Federal Signal Model SL86A Traffic Advisor f equivalent will be provided and installed at the back of the cab <br />on the headboard facing the rear of the truck. <br />Work Li hits: <br />One (1) 12 volt worklight will be installed on the crane and controlled by a switch located on the crane pedestal. <br />Two (2) 12 volt Federal Signal Model COM750-RN© LED lights with swivel mounts will be installed on the left <br />and right sides at the rear of the truck. These lights wilt be controlled by a switch located inside the cab. <br />Two (2) Wheien Pioneer Plus Senes 12 Volt LEO 1 equivalent combinalion flood — spotlights with telescoping <br />holes will be provided and installed on ft front left and right sides of the truck body. Lights will have onloff <br />switches mounted on the light head. <br />Paint and finish: <br />Body exterior and compartment interiors to be painted. white to match the cab <br />All surfaces to be acid etched, cleaned of rust, grease, oil, dirt, miliscale, etc., prior to the prime coat of <br />paint. <br />All exterior and interior surfaces coated with minimum two coats of metal primer Body exterior painted <br />with minimum two coats paint to match cab <br />Body compartment interiors painted with a minimum two coats of white paint. <br />All installed switches andlor equipment control(s), must be property labeled as to function and condition <br />(i.e., on, oil, etc.). All required identification labels or placards, interior or exterior, to be pernoanent non - <br />fading (i.e., engraved or die -stamped) and affixed using rivets. Adhesive labels, metal or plastic, are <br />not acceptable <br />• Page 6 <br />326 <br />