Laserfiche WebLink
REV: 04-29-25 LF <br />•Breathing air pressure (if applicable). <br />•Engine diagnostic indicators (Stop Engine, Check Engine, and Regen). <br />Controlled by the IQAN system, a collision avoidance system shall be provided utilizing E-Zone™ <br />technology on the rotation and elevation systems to alert the aerial device operator when rotating <br />left or right at low angles and or lowering the ladder near the truck. <br />The E-Zone™ system shall automatically stop rotation or lowering functions when the device is <br />in the defined zone. The system shall sound an audible alarm and display a warning on the display <br />while in an avoidance zone. To leave an avoidance zone, the operator must either rotate in the <br />opposite direction or elevate the ladder above the defined zone. <br />Standard avoidance zones include: <br />•Cab avoidance (except for TDA units). <br />•Body avoidance. <br />•Tiller Cab avoidance (TDA units only). <br />The IQAN system shall also provide E-Cush™ technology when approaching extension limits, <br />elevation limits, or avoidance zones. In these cases, the system shall throttle down allowed <br />hydraulic flow the closer the aerial is to the physical stop or programmed zone. This will provide <br />a more controlled stop. <br />The IQAN system shall also provide motion ramping. This highly configurable system will <br />automatically create more gradual starts and stops to ladder motion. If the operator is smoothly <br />ramping the electric joysticks themselves, the system will have to do provide minimal intervention. <br />In the case of a rapid speed change (including releasing the joystick back to neutral during <br />movement), the system will ramp the output up/down until it reaches the desired speed. Motion <br />can always be halted immediately using the operator presence foot switch. <br />The aerial speed control dial allows the turntable operator to adjust the maximum operation speed <br />of the aerial from 50% to 100%. This is especially useful when training new operators or when <br />working in a congested area. <br />AERIAL TRAVEL SUPPORT <br />A heavy-duty rest shall be provided to support the aerial in the travel position. The rest shall be <br />constructed as part of the ground ladder superstructure and painted to match the trailer frame. <br />Stainless steel bedding plates shall be attached to the aerial base section to protect the aerial <br />when the unit is in the travel position. <br />AERIAL TRAVEL SUPPORT ILLUMINATION <br />A single Fire Tech model FT-WL-2000 series work light shall be installed to illuminate the travel <br />support during nighttime operations. <br />ATTY/AGR.2025.089/Fire Apparatus Solutions (Purchase of Spartan-LTC 105' TDA) (Page 140 of 150)