Reso25 16367 - Laserfiche WebLink

Browse Search

Page 9 of 12 # FIRE Conditions Compliance F3 Fire Hydrant and Sprinkler Feed Lines. All water mains that provide a water supply for fire protection (both to fire hydrants and fire service systems) shall not be less than eight inches in diameter. The Applicant is responsible for fulfilling this condition and shall submit plans to the Fire Marshal’s Office for review and approval. Water supply for fire protection is required to be installed in accordance with water purveyor’s specifications. The water supply shall be tested, flushed and approved operable prior to any combustible construction materials being placed on the site. Staged construction shall ensure that the necessary water supply is maintained from stage to stage in the construction planning. [CFC §507.1.1 as amended by the City of Redwood City Code of Ordinances §12.16][SDR] Prior to Building Permit Issuance F4 Fire Lane Signs. Mark fire apparatus access roads with permanent NO PARKING-FIRE LANE signs and/or painted curbs in accordance with state and local standards. Submit plans to the Fire Marshal’s Office for review and approval. [CFC 503.3] [SDR] Prior to Certificate of Occupancy F5 Fire Resistive Construction Inventory. Maintain an inventory of all required fire resistance rated and smoke barrier construction, and repair records when damaged, altered breached or penetrated. [CFC §701.2 and §701.6][SDR] Ongoing Record Keeping F6 Fire Resistive Construction Maintenance. The fire resistance rating of structural members, exterior walls, fire walls, fire barriers, fire partitions, horizontal assemblies and shaft enclosures, and the smoke resistance of smoke barriers and partitions, shall be maintained and repaired to equivalent fire or smoke resistance when damaged during demolition or alteration. Annual visual inspection and repair records shall be maintained. Annual inspections shall use the Compliance Engine software or successor software specified by the Fire Marshal. [CFC §701.2 and §701.6][SDR] Annual Inspection F7 Hazardous Materials. Ensure that a master building wide Hazardous Materials Inventory Statement (HMIS) and a tenant HMIS are kept on file with the building management for the lifetime of the use. The building management shall manage all tenant HMIS documents against the Master HMIS such that the total quantity of hazardous materials shall not exceed the Maximum Area Quantities (MAQ’s) as defined by the HMIS and CFC Chapter 50. Where hazardous materials are to be used or stored, increase fire sprinkler design density to 0.4gpm/sq ft/3,000 square feet. [CFC 5001.5.1][SDR] Ongoing F8 Public Safety Key Boxes. Provide approved Knox® key boxes adjacent to each building entrance. Public safety key boxes shall be recessed and installed adjacent to each entrance within 60 to 72 inches of the finished walking surface. There shall be four sets of keys: each set containing building access, fire equipment room access, fire cache room, elevator keys, utility room keys and other keys essential for emergency operations. [CFC §506.1][SDR] Prior to Certificate of Occupancy # PLANNING Conditions Compliance P1 Use. The project approval is for a Public Use Facility. Any change to the approved use is subject to review and approval by the City. Notwithstanding permitted uses in the district where the project is located, only land uses reviewed and approved in this application are permitted for the project location. Any change in use beyond the permitted uses in the district are subject to review and approval by the City. [COA] Ongoing P2 Ongoing Use Obligations/Operations. Comply with all terms of the Master Project Agreement approved by Resolution No. 15814, dated December 16, 2019, including all amendments to the Master Project Agreement, related to the operations of the project. [COA] Ongoing ATTY/RESO.0110/CC RESO APPROVING ARCHITECTUAL PERMIT (YMCA PROJECT) – EXHIBIT A REV: 11-06-25 VR