Reso25-12 0126 PC Reso 1320 Marshall Street Project

Metadata

Thumbnails

Annotations

ATTY/RESO.0126/PC RESO 1320 MARSHALL STREET PROJECT – EXHIBIT A REV: 12-10-25 VR Page 7 of 13 # ENGINEERING & TRANSPORTATION Conditions Compliance E19 Elevation Certificate. Submit elevation certification of the lowest floor (including basement) by a registered professional engineer or land surveyor. The City’s Building Inspector shall verify the building to be properly elevated and provide documentation to the Floodplain Administrator. Where required by Chapter 41 of the City’s Municipal Code, the Applicant shall also submit certification by a registered professional engineer or architect that the standards for elevation and floodproofing have been satisfied. [Section 41.18 et seq. of Municipal Code][SDR] Prior to Certificate of Occupancy per Building E20 Conformance with City Engineering Standards. Design and construct all improvements in accordance with the City's Engineering Standards. [Section 29.1 of Municipal Code][SDR] Prior to Building Permit Issuance E21 Encroachment Permits. Obtain an Encroachment Permit from the Engineering and Transportation Division prior to commencement of work listed below. The City requires insurance for such work that meets its standards. This can include the following: a. Work in the City public right-of-way, easements, or property in which the City holds an interest. b. Work requiring a grading permit. Grading permits require a Plot and Finished Grading Plan prepared by a California-registered Civil Engineer. c. Work requiring on-site shoring which affects the public right of way. d. Any fixed structure (awnings, roof overhangs, fixed planters, etc.) to be constructed within the public right-of-way. [Section 29.3 of Municipal Code][SDR] Prior to Building Permit Issuance E22 Undergrounding Utilities. Underground all overhead utilities along the project frontage of Marshall Street, to the next existing off-site utility pole, or pay the applicable in-lieu fee. Underground all electrical, telephone, and cable TV services to the site (note that there is in-lieu fee available in the Municipal Code). Identify these utilities on the building permit plans. [Section 18.242 of Municipal Code][SDR] Prior to Final Certificate of Occupancy for the project E23 Final Utility Report. Submit and obtain approval of a Final Utility Report prepared by a licensed engineer demonstrating that the existing utilities have sufficient capacity for the project. The study shall consider existing, project, other approved projects, and applications currently under review in determining the needed capacity. If the existing utilities are substandard or is in any other way not sufficient as determined by the City Engineer, Applicant shall, as part of the Project, construct and install new utilities sufficient to meet such requirements, in accordance with the City's Engineering Standards and as directed by the City Engineer. [Section 29.1 of Municipal Code][SDR] Prior to Building Permit Issuance E24 Sewer Lateral Limit. Demonstrate that the project has one sewer lateral connection from the site to the city sewer main. [Engineering Standards - Design Criteria, Part VI][SDR] Prior to Building Permit Issuance E25 Sewer Lateral Size. Upgrade all sewer laterals less than 4’’ wide to a minimum of 6” in size and show on the building permit plans. [Engineering Standards - Design Criteria Part VI][SDR] Prior to Building Permit Issuance E26 Water Mains. Submit and obtain approval of an evaluation and report, prepared by a licensed engineer, in conformance with the City's Engineering Standards, demonstrating that the proposed water main meets the domestic and fire flow requirements in accordance with City Code Section 38.26 and the International Fire Code. If the existing water main is less than 6” in size or is in any other way not sufficient as determined by the City Engineer, Applicant shall, as part of the Project, construct and install Prior to Building Permit Issuance