Laserfiche WebLink
��-5� <br /> Step 4 +� <br /> Screw on the two exisGng 1/2" hose connec- <br /> tions to the corresponding hot and cold sides <br /> � of the pump housing (see fig. 4). Be sure not <br /> to "kink" these existing hose lines during <br /> bending which may prevent adequate flow <br /> and/or cause the valves to break. <br /> Note: k is recommended that the rubber -�r� <br /> washers in ffie hose connections be <br /> inspected to ensure they are in reusable � <br /> condition. if not, they should be replaced. <br /> .'� �, d� <br /> _ � � <br /> Step 5 � <br /> Screw on the 318" end of the purchased flexible � <br /> hoses to the 3/8" connections on the pump , <br /> housing. Screw on the 1/2" end of these same <br /> lwo hoses to the under$ide of the hot ar�d cold <br /> water faucets making sure to match the hot and <br /> cold sides marked on the pump housing with the <br /> ccrresponding faucet. Be sure the hot side �� <br /> connection hose is attached to the hot water _� <br /> faucet and the cold water side connection is � <br /> attached to ihe cold water faucet. Be sure the w� <br /> hoses used are loiig enough to allow the pump <br /> to be positioned as onginally planned. '=� 1 -� <br /> 5t�p 6 <br /> Be sure the screw ring attaching the motor to the pump housing is securely hand <br /> ;ightened. Do not over tighten the screw ring. Then open the faucet hot and cold <br /> riser shut off valves co insure there are no water leaks at any connectians. <br /> Step 7 <br /> Plug the pump cord into the wal: outlet and start up the pump system (see next <br /> page). <br /> �- U.L Cautian � � <br /> This pump haa boen testad using water only. Ifs suitability for use with liquids othanthan -� . <br /> watar ia tha end ueaYs responsibility. .. <br /> 5 <br />