Laserfiche WebLink
i. All wood surfaces to be cleaned and prepared prior to application of product <br /> b. Doar casings <br /> i. All surfaces to be thoroughly sanded and cleaned prior to primer application <br /> ii. Primer-Rustoleum Sierra Performance#S30 Grip tec acrylic primer <br /> iii. Finish—Rustoleum Sierra Performance#S37 Metalmax DTM Acrylic <br /> Enamel—(color TBD) <br /> c. Smoke seal <br /> i. Remove existing smoke seals <br /> ii. Install mechanically fastened smoke seal after painting is complete <br /> Remodel of Entrv Wav Shall Include Items Listed Below At Nos. l-3: <br /> 1. Floors <br /> a. Floors <br /> i. Remove existing flooring <br /> ii. Prepare floors and provide floor seal product-Bostik Dura bond D261 epoxy <br /> iii. Install Armstrong excelon VCT vinyl floor covering(color TBD) <br /> iv. Install cove base product? <br /> 2. Walls <br /> a. Paint—Kelly Moore-Durapoxy-product 1686-14—Frost <br /> b. Install 1"x4" clear fir chair rail at 4' height as needed to separate Rigid vinyl from <br /> tack able surfaces. (Review specific areas with owner during pre-bid job walk.) <br /> c. Rigid Vinyl <br /> i. InPro-Il'C Rigid vinyl sheets- .080 thickness, (color TBD) <br /> ii. To be installed from floor to 4',EXCEPT in sink areas where it is to be <br /> installed from floor to 8' <br /> d. Tackable surface <br /> i. Install fabric covered tackable wall panels on wall opposite entry doors <br /> ii. Tackable panels will cover walls from 4' off the ground to 8' off the ground <br /> 3. Ceiling(T&G wood ceiling) <br /> i. All wood surfaces to be cleaned and prepared prior to application of product <br /> Page 13 of 19 <br />