Agmt16 Wilsey Ham - Laserfiche WebLink

Browse Search

7. Remove and replace blowers and vents for the wet well and valve vault with Hartzell fans. Install new Hartzell fan model #A42-4-10-F100GFXFC 286 CFM or approved equai. 8. Remove and replace existing wet we II guide rails. 9. Remove existing wet well ladder. 10.Remove and replace flow meter, couplings, adapters, pressure gauges, pipe supports andotherappurtenances. 11.Remove and replace existing sanitary sewer pump station's motor control center and update all existing MCC equipment and cabinet with Tesco Motor Control Center Unit or approved equal. (e.g. NEMA enclosures, circuit breakers, transformers, power relays, timers, starters, automatic transfer switch, etc.) Motor Control Center cabinet should be sized as required to fit all components. 12.Remove and replace existing VFD. Install new Allen Bradley RFX 400 or Cutler Hammer Model SV 9000 new variable frequency drive (VFD) for each pump including all components and appurtenances to support Flygt submersible pumps as required. The said models of VFD are being used by the City in its other existing pump stations. 13.Update sanitary sewer programmable logic controller (PLC) unit with Allen Bradley Micro Logix 1400 or approved equal. 14.Verify existing electrical connections and electrical bad capacity to conform to the installation of new sanitary sewer pump station's motor control center, PLC unit and new Flygt submersible pumps. 15.Coordinate with utility companies to obtain record information that maybe affected by the design or construction of the sanitary sewer pump station. 16.Coordinate with EDCCO for SCADA control system programming work. Contact Eric Daniel at 650-63-SCADA. 17.Connect to existing force mains. Point of connection to be field verified. 18.Conduct start-up and testing of inechanical and electrical structures and equipment. 19.Remove and replace existing AC pavement. 20.Remove and replace existing concrete pad, concrete pavement, concrete sidewalk and curb and gutter. 21.Furnish and install 2 inch recycled water pipeline, quick coupler valve, backflow preventer and other appurtenances. 22.Landscape restoration including but not limited to grass lawn, plants and etc. 23.Perform field investigation of the existing pump station facility to verify existing conditions. The above products specified are to replace existing equipment or products. Recommendations from consultant is requested and will be reviewed by City. C. SCOPE OF SERVICES Consultant shall perform and provide the following: REV:01-04-16 VR Page 12 of 18 ATTY/AGR.2016.001/Wilsey Ham-Engineering, Surveying&Planning