Agmt16 Wilsey Ham - Laserfiche WebLink

Browse Search

2. Consultant shail review existing pump station background information. Conduct site visit to the pump station site to assess the condition and provide recommendation for mitigation of wet well liner. 3. Consultant shall contact utilities agencies and coordinate relocation, if necessary. Show utilities on drawings. 4. Consultant shall evaluate whether existing PG&E service is adequate for the improvements. If not, coordinate with PG&E for installation of new electrical service. Submit documents for service application, if needed. 5. Consultant shall coordinate with City's SCADA consuttant, The EDCCO Group, for the design of the RTU/PLC unit and control system programming. 6. Consultant shall coordinate with Bay Area Air Quality Management District (BAAQMD) regarding newgenerator permit requirements. 7. Consultant shall prepare for review by City, 75% complete construction drawings consisting of plan views, profiles, cross-sections, construction notes, detailing of major components, utility connection points, specification outline, construction cost estimates, construction schedule and other documents, including but not limited to, details, catalogue cuts, product literature for all products, and engineering calculations. Deliverables: Six (6) sets of seventy-five percent (75%) plans (24"x36" plan sheets), specification outline, and Engineer's Estimate shall be presented to the City for review. The City will provide the City's standard title block. A marked set will be returned along with City staff s comments and/or request for clarifications to the Consultant for revision. One meeting shall be scheduled with City staff after review of the 75% submittal prior to proceeding with the 100% Final Design Submittal. TASK 4- FINAL DESIGN(100%DESIGN SUBMITTAL) With the City's approval, the Consultant shall proceed with the Final Design. Specific tasks in this phase include, but are not limited to, the following: 1. Consultant shall incorporate 75% Design Submittal review comments. 2. Consultant shall prepare 100% Design Submittal consisting of complete construction documents including drawings, specifications and cost estimates. The submittal shall also include, but not limited to, site grading plan, cross section details, structural details, complete technical specifications, estimate of construction cost, electrical details, civil details, structural details, mechanical details, and any catalogue cuts for any special material proposed for use in the project. One meeting shall be scheduled with City staff. 3. The 100% Design Submittal shall be ready for signature and submitted to the City for review and approval. A marked set will be returned along with staff s comments and/or request for clarifications for revision. REV:01-04-16 VR Page 14 of 18 ATfY/AGR.2016.001/Wilsey Ham-Engineering, Surveying&Planning