AgdaPkt 2018-03-26 Joint SA PFA - Laserfiche WebLink

Browse Search

REV: 03-16-18 MI ATTY/AGR/2018.054/RECOLOGY OF SAN MATEO Page 61 of 119 Contractor shall maintain a spare ratio of ten percent (10%) for all Collection vehicles 2474 used in the SBWMA Service Area. It is contemplated that, as of the Commencement 2475 Date, all Collection vehicles will be vehicles that Contractor purchased during the term 2476 of the 2009 Franchise Agreement and will be nearing the end of their useful life. 2477 Contractor shall purchase and place into service after the Commencement Date all 2478 new vehicles to replace its Collection vehicles and other vehicles used by Contractor 2479 in the SBWMA Service Area in accordance with the Contractor-prepared equipment 2480 replacement schedule in Attachment N. The new vehicles shall replace all vehicles in 2481 service on the Commencement Date. The vehicles shall be purchased and placed in 2482 service in accordance with the timeline shown in Attachment N unless an alternative 2483 timeline is agreed upon by the SBWMA provided that all new vehicles shall be in 2484 service on or before June 15, 2026. The estimated depreciation and interest 2485 expenses for the acquisition of new vehicles shall be included in Contractor’s 2486 Compensation for 2021 and adjustments during the Term shall be made in 2487 accordance with Attachment K. Agency has no responsibility to pay Contractor for 2488 remaining net book value of any Vehicles, Containers, or other equipment that is not 2489 fully depreciated at end of Term, unless Agency elects to purchase Containers 2490 pursuant to Section 8.05.F of the Agreement. 2491 At no time after the Commencement Date shall any vehicle used to perform the 2492 services required under this Agreement exceed fifteen (15) years of age from the first 2493 date the vehicle was registered unless agreed upon by the SBWMA. Collection 2494 vehicles and other vehicles whose acquisition costs are included in the calculation of 2495 Contractor’s Compensation may be used only in the SBWMA Service Area. 2496 B. General Vehicle Specifications 2497 1. All vehicles used by Contractor in providing Solid Waste, Targeted Recyclable 2498 Material, and Organic Material Collection services shall be registered with the 2499 California Department of Motor Vehicles. 2500 2. All Collection vehicles shall have leak-proof bodies designed to prevent leakage, 2501 spillage, and/or overflow and shall be designed so that Collected materials are 2502 not visible. 2503 3. All vehicles shall comply with California Environmental Protection Agency (EPA) 2504 noise emission regulations and California Air Resources Board air quality 2505 regulations and other applicable pollution control regulations. 2506 4. All Collection vehicles shall have cameras to monitor driving and loading 2507 activities including, at a minimum: (i) back-up cameras mounted at the rear and 2508 side of the vehicle; and, (ii) a hopper camera clearly displaying the contents of 2509 the hopper prior to compaction. 2510 5. Contractor shall be required to operate an adequate number of Collection 2511 vehicles that shall be capable of servicing hard-to-service areas and accessing 2512 long driveways in the Service Area. 2513 6. All Collection vehicles shall be capable of unloading materials in the Designated 2514 Transfer and Processing Facility buildings taking clearance heights, especially 2515 in the MRF, into consideration. 2516 7. All Collection vehicles shall be equipped with and shall utilize on-board 2517 computers and GPS tracking devices with real-time transmission to all levels of 2518 6.2.B. - Page 74