Laserfiche WebLink
Lighting Installations <br />d. LM -61-06 (Most current), IESNA Approved Guide for Identifying Operating Factors <br />Influencing Measured Vs. Predicted Performance for Installed Outdoor High Intensity <br />Discharge (HID) Luminaires <br />e. LM -79-08 (Most current), IESNA Approved Method for the Electrical and Photometric <br />Measurements of Solid -Sate Lighting Products <br />f. LM -80-08 (Most current), IESNA Approved Method for Measuring Lumen Maintenance <br />of LED Light Sources <br />g. RP -8-00 (Most current), ANSI / IESNA American National Standard Practice for Roadway <br />Lighting <br />h. RP -16-10 (Most current), ANSI/IES Nomenclature and Definitions for Illuminating <br />Engineering <br />i. TM -3-95 (Most current), A Discussion of Appendix E - "Classification of Luminaire <br />Lighting Distribution," from ANSI/IESNA RP -8-83 <br />j. TM -15-11 (Most current), Luminaire Classification System for Outdoor Luminaires <br />k. TM -21-11 (Most current), Projecting Long Term Lumen Maintenance of LED Light <br />Sources <br />5. National Electrical Manufacturers Association (NEMA) <br />a. ANSI/NEMA/ANSLG C78.377-2008 (or latest), American National Standard for the <br />Chromaticity of Solid State Lighting Products <br />6. National Fire Protection Association (NFPA) <br />a. 70— National Electrical Code (NEC) <br />7. Underwriters Laboratories (UL) <br />a. 1449, Surge Protective Devices <br />b. 1598, Luminaires. <br />c. 8750, Light Emitting Diode (LED) Equipment for Use in Lighting Products LED Roadway <br />Specification <br />8. CSA <br />a. 1598, Luminaires <br />B. GENERAL CONSTRUCTION FOR LED LIGHT FIXTURES AND MOUNTING ARMS <br />1. LED light fixtures and mounting arms shall be CSA Certified to U.S. Standards and shall comply <br />with ANSI: C136.2, C136.10, 0136.14, C136.15, C135.31 and C136.37. <br />2. Luminaire housing shall be fabricated from die cast aluminum low copper content alloy. <br />a. Luminaire housing shall act as passive heat sink for LED Array. The use of fans or gels is <br />prohibited. <br />b. Housing shall be designed in such a manner that debris build-up with -in "heat -fin" <br />structure will not significantly impact lamp lumen depreciation (LLD). <br />c. Luminaire finish and casting shall be tested to ASTM B117 salt fog, and must maintain <br />a scribe creepage rating of 7 per ASTM D1654 after 5000 hours. <br />d. Luminaire shall have a hinged doorframe for quick access to internal components. <br />e. Luminaire shall have die-cast trigger latch on doorframe allows for tool -less entry. <br />f. Tool -less access shall accommodate user wearing electrical gloves. <br />g. Weight of fixture shall not exceed 14 lbs. <br />h. EPA of fixture shall not exceed 0.76 Sq. Ft. <br />i. Luminaire shall have rectangular form factor to match existing fixture housing. <br />Page 7 of 13 <br />Rev:M��7" 2019.059/All Industrial Electric Supply, Inc./LED Street Lights <br />