Res19 15769 - Laserfiche WebLink

Browse Search

05/20/2019 Connection Control Specialist Certified through the CA -NV Section of the AWWA and observed by Public Works staff. The cross -connection control test method must be included in the Recycled Water Report. The applicant is responsible for all fees associated with the performance of the cross -connection control test. [COA] [ENGINEERING] 42. Discharge Permit for Subterranean Garages - If the subterranean garage requires groundwater pumping into the sewer system, a Discharge fee will apply and a Discharge Permit will be required by Silicon Valley Clean Water (SCVW) prior to issuance of the building permit. [SDR][ENGINEERING] 43. Backflow Protection - Backflow protection on all water services is required. The backflow preventer shall be above grade and located on private property as close as practicable to the water meter, and accessible to the Public Works Department for testing. [CCA] [ENGINEERING] 44. Fire Flow - The Project shall meet fire flow requirements as established by the Fire Department which are based on the Fire Code. Fire flow tests are typically performed duringthe preliminary design phase but must be completed prior to submittal of final design. Applicant shall contact the Fire Department for Fre flow requirements, and then submit a written fire flow test request to Engineering. [COA][ENGINEERING] 4S. C3 Requirements - Plans shall be designed to meet C3 requirements of the Municipal Regional Permit (MRP) NPDES Permit CAS612008 and be in compliance with San Mateo County C.3 Stormwater Technical Guidance. [SDR] [ENGINEERING] a. Treatment Controls -Treatment measures to be shown on final improvement or grading plans shall not differ materially from the treatment measures presented on the project's Vesting Tentative Map, without written approval from the Engineering Department. b. Treatment Measure Inspection - Applicant shall coordinate installation of stormwater treatment measures with the municipality, shall arrange to have the City's designated inspector present at the time of installation, and shall have the City's designated inspector complete a final inspection of installed stormwater treatment measure immediately after installation is complete. 46. Stormwater Management Plan (SWMP) - Applicant shall prepare a SWMP that includes, at a minimum, exhibit(s) showing drainage areas and location of Low Impact Development (LID) treatment measures; total project site area and total area of land disturbed; total new and/or replaced impervious area; treatment measures and hydraulic sizing calculations; a listing of source control and site design measures to be implemented at the site; saturated hydraulic conductivity rate(s) at relevant locations or hydrologic soil type (A, B, C or D) and source of information; elevation of high seasonal groundwater table; and a brief summary of how the project is complying with Provision C.3 of the MRP. [COA][ENGINEERING] 47. Construction General Permit - For construction activity resulting in a land disturbance of one acre or more, applicant shall file a Notice of Intent (N01) with the State Water Resources Control Board under the Construction Activities Storm Water General Permit (General Permit). The N01 indicates the applicant's intent to comply with the San Mateo Countywide Stormwater Pollution Prevention Program, including a Stormwater Pollution Prevention Plan (SWPPP). [SDR] [ENGINEERING] ATTY/RESO.0051 CC RESO APPROVING PROJECT— BROADWAY PLAZA RESO. NO. 15769 REV: 05-15-19 PR MUFF No. 601 Page 16 of 22