Reso23-15 Reso 0049 PC23-15 PC Reso Re...lan Amendments and DTPP Amendments

Browse Search

local. regional, state or federal agencies, review and approve or conditionally approve the Use Permit and related safety plans (including the Biosafety Plan, Evacuation Plan. and Medical Waste Management Plan). Compliance with this requirement shall be verified by the Planning Manager/Designee prior to issuance of building permit or Certificate of Occupancy. F) All operations, including storage. shall be located inside a building to reduce noise, vibration, odor, glare, or dust impacts on the surrounding area or sensitive receptors. a. Emergency generators may be placed outside the building, but must be screened from view and comply with Redwood City's Noise Ordinance. Any routine testing of emergency generators shall be conducted between the hours of eight (8) a.m. to six (6) p.m. Monday through Friday. b. All building mechanical equipment shall be screened from public view and the materials used to screen shall relate to the building's design and massing. c. A Research and Development. Laboratory use shall install a Building Automation System (BAS) that is programmed to either dim or turn interior lights off or to lower shades after 9:30 pm to reduce light pollution and glare. G) For uses involving the manufacturing. use, or storage of hazardous materials, as defined in the California Health and Safety Code, the quantities and types shall be subject to the limitations established by the current California Building Code and Fire Code. A valid permit from the Certified Unified Program Agency (CUPA) shall be required prior to the delivery, use, manufacturing, and/or storage of hazardous materials in the building. a. The materials for a Research and Development. Laboratory use shall be limited to the applicant on the subject site and not used outside of the subject development. The storage of hazardous materials shall be prohibited outdoors and shall be located completely within the building (for new development) or in -a detached structure if infeasible to accommodate within an existing building. H) New development projects shall include a loading and unloading zone as part of the project which is inside the proposed building. The loading and unloading zone shall not be located on the primary public facing side of the building when feasible, as determinedby the Planning Manager/Des(gnee. 1) Research and Development. Laboratory uses shall comply with the specific mitigation measures outlined for this use in applicable environmental review documents. Sec. 2.3 - NEW STREETS (PAGE 50) Replace Map with Figure 2.3 -New Streets Map Sec. 2.4 - PUBLIC FRONTAGE REGULATIONS (PAGE 54) Replace Map with Figure 2.4 -Public Frontage Map (Page 55) Replace Chart with Figure 2.4 -Public Frontage Chart (Page 57 - Add the following image with caption: "Lumec Contemporary') ATTY/RESO.0049/PC RESO RECOMMENDING APPROVAL OF GENERAL PLAN AMENDMENTS AND DTPP AMENDMENTS - EXHIBIT A REV: 06-07-23 VR Page 11 of 19