Laserfiche WebLink
REV: 04-29-25 LF <br />TOW EYES <br />There shall be two (2) tow eyes installed on the apparatus. One (1) on each rear frame rail. The <br />tow eyes shall be connected directly to the frame rails and extend outside the rear vertical wall. <br />The tow eyes are to have an inside diameter of approximately 3.00 inches and shall be painted <br />to match the frame color. <br />LOW-VOLTAGE ELECTRICAL SYSTEM (MULTIPLEX) <br />Common power distribution areas shall be located at various points on the body and pump area <br />(if applicable). These power distribution areas shall include the multiplexing input/output modules. <br />Additional electrical components in these areas may include, but not be limited to, common power <br />and ground studs, ground busses, solenoids, terminal strips, relays, and circuit breakers. All <br />circuits shall have some form of circuit overcurrent protection either internal to the multiplexing <br />device or external in the form of fuses or circuit breakers. <br />Wiring shall conform to the appropriate section of NFPA Standard for Automotive Fire Apparatus, <br />including wire type, identification, and rating; sizing for voltage drop and current load; and <br />connections and terminations. Wiring protection shall include loom and braid and also meet the <br />appropriate section of NFPA Standard for Automotive Fire Apparatus, including temperature and <br />moisture protection. Connections shall be made using Deutsch connectors, Packard connectors, <br />ring terminals, and terminal lugs, as well as other accepted practices. The body and pump <br />compartment (if applicable) shall be bonded to the vehicle frame. <br />PERIMETER LIGHTS LOCATION <br />There shall be eight (8) underbody perimeter lights installed on the apparatus positioned to <br />provide illumination to the immediate ground area around the unit. <br />Three (3) on each side of the apparatus, under the body compartments forward of the trailer axle <br />and two (2) under the rear of the apparatus. <br />PERIMETER LIGHTS <br />The underbody perimeter lights provided will be TecNiq model T44 series, 4” round, 8 diode LED <br />lights. <br />PERIMETER LIGHTS ACTIVATION <br />The perimeter lights under the body shall be activated with activation of the chassis ground lights. <br />UPPER LIGHTING PACKAGE <br />The following NFPA lighting package, manufactured by Whelen, shall be supplied and installed <br />in the upper areas of the vehicle. <br />UPPER ZONE C: <br />There shall be two (2) Whelen model MCFLED2* Ultra Freedom Micro Edge LED mini lightbars <br />provided and installed at the rear upper outboard corners of the apparatus, one (1) each side. <br />ATTY/AGR.2025.089/Fire Apparatus Solutions (Purchase of Spartan-LTC 105' TDA) (Page 105 of 150)