Agmt25 Kalmikov Enterprises,Inc.

Browse Search

REV: 04-29-25 LF CAB PAINT EXTERIOR The cab exterior shall be painted two tone per City’s specified paint colors following the RFG-SR- 001 paint standards. CAB PAINT PROCESS/MANUFACTURER The cab shall be painted with PPG Industries paint prior to the installation of glass accessories and all other cab trim to ensure complete paint coverage and the maximum in corrosion protection of all metal surfaces. All metal surfaces on the cab shall be mechanically etched by sanding disc to remove any surface oxidation or surface debris which may hinder the paint adhesion. Once all imperfections on the exterior surfaces are removed and sanded smooth, body fillers shall be applied to the cab on all surfaces that require a critically aesthetic finish and sanded smooth. The entire cab shall then be coated with a high-quality base primer that is designed to fill any minor surface defects, provide an adhesive bond between the primer and the paint and improve the color and gloss retention of the color. The finish to this procedure shall be sanding the cab to a smooth finish followed by sealing the seams with an automotive seam sealer. The minimum thickness of the primer coat after sanding shall be 2.50 mils with a maximum thickness of 5.00 mils. The cab shall then be painted the specific color(s) designated by the City with an acrylic urethane type system designed to retain color and resist acid rain and most atmospheric chemicals found on an emergency scene. The paint shall have a minimum thickness of 1.00 mils with a maximum of 4 mills, followed by a clear top coat with a minimum of 2.5 mils and a maximum of 3.5 mils. The entire cab shall then be baked to speed the curing process of the coatings. CAB PAINT PRIMARY/LOWER COLOR The lower paint color shall be Dupont 817520EX Red CAB PAINT SECONDARY/UPPER COLOR The secondary/upper paint color shall be PPG FBCH 903653 white. CAB PAINT EXTERIOR BREAKLINE The upper and lower paint shall meet at a breakline on the cab which shall be located approximately 1.00 inch below the door windows on each side of the cab. The breakline shall curve down at the front cab corners to approximately 5.00 inches below the windshields on the front of the cab. CAB PAINT PINSTRIPE Where the upper and lower paint colors meet a temporary 0.50 inch wide black pinstripe shall be applied over this break line to offer a more finished look prior to the final pinstripe being installed by the OEM. ATTY/AGR.2025.089/Fire Apparatus Solutions (Purchase of Spartan-LTC 105' TDA) (Page 25 of 150)