Agmt25 Kalmikov Enterprises,Inc.

Browse Search

REV: 04-29-25 LF AIR HORN The front bumper shall include two (2) Hadley brand E-Tone air horns which shall measure 18.00 inches long with a 6.00 inch round flare. The air horns shall be trumpet style with a chrome finish on the exterior and a painted finish deep inside the trumpet. AIR HORN LOCATION The air horns shall be recess mounted in the front bumper face, one (1) on the right side of the bumper in the outboard position relative to the right-hand frame rail and one (1) on the left side of the bumper in the inboard position relative to the left-hand frame rail. AIR HORN RESERVOIR One (1) air reservoir, with a 1200 cubic inch capacity, shall be installed on the chassis to act as a supply tank for operating air horns. The reservoir shall be isolated with a 90 PSI pressure protection valve on the reservoir supply side to prevent depletion of the air to the air brake system. ELECTRONIC SIREN SPEAKER There shall be one (1) Cast Products Inc. model SA4301, 100 watt speaker provided. The speaker shall measure 6.20 inches tall X 7.36 inches wide X 3.06 inches deep. The speaker shall include a flat mounting flange which shall be polished aluminum. ELECTRONIC SIREN SPEAKER LOCATION The electronic siren speaker shall be located on the front bumper face between the frame rails in the left side inboard position. FRONT BUMPER TOW EYES The bumper shall include two (2) chrome plated tow eyes shall be installed through the front bumper. The eyes shall be fabricated from 0.75 inch thick #1020 ASTM-A36 hot rolled steel. The inside diameter of the eye shall be 2.00 inches and include inside/outside chamfered edges. CAB TILT SYSTEM The entire cab shall be capable of tilting approximately 45-degrees to allow for easy maintenance of the engine and transmission. The cab tilt pump assembly shall be located on the right side of the chassis forward of the front axle behind the officer’s door area. The electric-over-hydraulic lift system shall include an ignition interlock and red cab lock down indicator lamp on the tilt control which shall illuminate when holding the “Down” button to indicate safe road operation. It shall be necessary to activate the master battery switch and set the parking brake in order to tilt the cab. As a third precaution the ignition switch must be turned off to complete the cab tilt interlock safety circuit. ATTY/AGR.2025.089/Fire Apparatus Solutions (Purchase of Spartan-LTC 105' TDA) (Page 51 of 150)