Laserfiche WebLink
6.1.C. - Page 8 <br />Bid specifications for Deere 310SJ or similar Wheel Loader Backhoe <br />Compliance <br />yes <br />no <br />The final drives shall be heavy -duty outboard planetary distributing loads over three gears <br />sealed in cooling oil bath for long -life and trouble free service. <br />es <br />no <br />The front axle shall have remote grease bank for front axle for easy access. <br />es <br />no <br />The rear axle bearings shall be self - lubricating and shall not need to be greased <br />es <br />no <br />The service brakes shall be inboard, wet - multiple disk, self- adjusting and self equalizing <br />and hydraulically actuated for a long and trouble -free life, sealed from water, mud and <br />dust contamination <br />es <br />no <br />The parking brake shall be independent of service brakes, spring applied, hydraulically <br />released, wet multi -disk, and sealed from water, mud and dust contamination. <br />Hydraulic System <br />es <br />no <br />Hydraulic cooler will have an independent reservoir for continuous running of attachments <br />at high ambient outside air temperatures <br />es <br />no <br />The hydraulic fittings shall have "O" -ring face seal connectors to secure a tight, leak -free <br />seal <br />es <br />no <br />The hydraulic filter shall be no more than 6 micron and will be vertically mounted, spin on <br />design for ease of installation and leak -free replacement. <br />es <br />no <br />An automatic bucket return -to -dig control will be standard <br />es <br />no <br />Hydraulic pump shall be 36 gpm (136L /min.) @ 2,200 rpm at 3,625 psi (24 993 kPa) gear <br />pump, open center system <br />Electrical <br />es <br />no <br />The backhoe shall have a 12 volt system with 90 amp alternator <br />es <br />no <br />Single battery shall be included, 12 volt, 950 CCA, 190 -min. rated reserve <br />es <br />no <br />The machine shall have blade type, multi -fused circuits <br />es <br />no <br />The starter shall have a bypass start safety cover <br />es <br />no <br />Cab will be pre -wired for rotating beacon and radio -ready <br />es <br />no <br />Unit shall be equipped with 10 halogen driving /working lights, (4) front driving /working; (4) <br />rear; (2) side docking lights The front lights shall be adjustable and the bulbs shall be no <br />less than 32,500 candlepower each. <br />es <br />no <br />Unit shall be equipped with two front and two rear turn signal /flashing and two rear stop <br />and tail lights and two rear reflectors <br />Operator Station <br />es <br />no <br />Unit shall be equipped with isolation mounted modular design ROPS /FOPS canopy and <br />molded roof <br />es <br />no <br />Access to the cab shall be from the right and left side with protected, wide, rigid, self - <br />cleaning steps and ergonomically located hand -holds <br />es <br />no <br />2" retractable seat belt shall be provided <br />es <br />no <br />Coat hook, built -in beverage holder, operator manual storage compartment, interior <br />rearview mirror and two 12 volt outlet shall be provided <br />es <br />no <br />Unit shall be equipped with illuminated electronic gauges with audible warning for: engine <br />coolant temperature, oil temperature and fuel level. <br />es <br />no <br />The monitor system shall have audible and visual warnings: engine air restriction, low <br />alternator voltage, engine oil pressure and temperature, hydraulic filter restriction, parking <br />brake on /off, and low brake pressure. The seat belt will have a visual warning. <br />es <br />no <br />The key start switch will have an electric fuel shut -off <br />es <br />no <br />The monitor will have a multi - language (English, French and Spanish) digital monitor for <br />diagnostics (including diagnostic messages and fault code readings), calibrations and <br />machine information. <br />8/9/2011 and 3:51 PM <br />Page 2 of 4 <br />