Laserfiche WebLink
3. Install Wire door pull on each door to match existing <br /> 4. Tall storage—See detail D on drawings provided at pre-bid walk <br /> a. Doors <br /> i. Remove existing full height doors and hardware <br /> ii. Salvage old locks for reuse by owner <br /> iii. Provide and install New locks to be keyed alike throughout <br /> iv. Install white matte finish on half size doors to match existing <br /> 1. Install three(3)Euro-hinges per door <br /> 2. Modify box to add styles to accommodate new doors <br /> 3. Fix adjustable shelf at top of bottom door. <br /> 4. Secure with cleat <br /> 5. Floors <br /> a. Floors <br /> i. Remove existing flooring <br /> ii. Prepare floars and provide floor seal product-Bostik Dura bond D261 epoxy <br /> iii. Install Armstrong excelon VCT vinyl floor covering(colar TBD) <br /> iv. Install cove base. 4" Burke cove base(color TBD) <br /> 6. Walls <br /> a. Paint—Kelly Moore-Durapoxy - product 1686-14 -Frost <br /> b. Install 1'x4' clear fir chair rail at 4' height as needed to separate Rigid vinyl from <br /> tack able surfaces. (Review specific areas with owner during pre-bid job walk.) <br /> c. Rigid Vinyl <br /> i. InPro-IPC Rigid vinyl sheets- .080 thickness,(color TBD) <br /> ii. To be installed from floor to 4",EXCEPT in sink areas where it is to be <br /> installed from floor to 8' <br /> d. Tackable surface <br /> i. Install fabric covered tackable wall panels on all walls <br /> ii. Tackable panels will cover walls from 4' off the ground to 8' off the ground <br /> e. Paint—Kelly Moore-Durapoxy-product 1686-14—Frost—At all areas above 8' <br /> Page 10 of 19 <br />